"Toller" wrote in message
...
I measured the current to the 8.6a motor on my table saw while ripping
some
6/4 oak with a combination blade. I figure that is about the heaviest I
ever stress it.
It measured 9.1a.
What should I make of that? Is it normal to go over the rating on heavy
loads? I haven't had any problems; I was just curious what the current
would be.


Peak meter or RMS meter?
Where did you measure?
When was the meter last calibrated?

How big of a cord are you using and how far are you from the source? (total
distance)

I have a 10 inch dewalt that I hammer occasionally. I just let the motor run
for awhile after I am done pushing it so it can cool off.