What to do with my 1hp delta shaper?
On Sat, 12 Nov 2005 10:51:17 -0600, Duane Bozarth
wrote:
Mark & Juanita wrote:
On Sat, 12 Nov 2005 09:46:54 -0600, Duane Bozarth
wrote:
...snip prior discussion large OD cutters on 1/2" spindle LD
shaper...
Just got new Wooddorkers Supply catalog so was thumbing through it last
night and happened to notice the Freud panel raisers for 3/4" spindles
are now (or maybe have been for quite some time and I never noticed
before since already had what I need in 1") being shipped w/ 1/2"
bushings and they're 5" OD.
I got my set about 3 years or so ago and it shipped with 1/2" bushings
then. So it's been a while.
Do you actually use them on a 1/2" spindle?
No, my shaper has 1/2, 3/4, & 1" spindles. I've settled on using 3/4 as
my "standard" size. I've never used the 1/2" for any cutters.
+--------------------------------------------------------------------------------+
If you're gonna be dumb, you better be tough
+--------------------------------------------------------------------------------+
|