Thank you all

Keith
Newfoundland

"Chuck" wrote in message
...
On Thu, 10 Nov 2005 06:32:13 -0330, "Keith Young"
wrote:

Hi

I am using the Beale buffing wheel system attached to an adapter and
motor.
My problem is that the wheel is very difficult to remove after use!
Sometimes I have to use vise grips attached to a screwdriver to get enough
leverage to remove the wheel as it tightens very security.

Any advice would be appreciated!

This is an easy one.

Cut a two or three inch circle from a plastic lid, like from the
cover to a can of coffee, a can of potato chips or any other thin,
pliable plastic. Put a hole in the center the same diameter as the
spindle and put it on before screwing the wheel on. Should be easier
to get off after that.

--
Chuck *#:^)
chaz3913(AT)yahoo(DOT)com
Anti-spam sig: please remove "NO SPAM" from e-mail address to reply.


September 11, 2001 - Never Forget

----== Posted via Newsfeeds.Com - Unlimited-Unrestricted-Secure Usenet
News==----
http://www.newsfeeds.com The #1 Newsgroup Service in the World! 120,000+
Newsgroups
----= East and West-Coast Server Farms - Total Privacy via Encryption
=----