"noonenparticular" wrote in message
m...

Leon,

I agree it's not much more difficult than regular raised panel door, but
there is the extra step of cutting the mortises for the muntins and rails
that doesn't need to be performed with a typical R&S construction. Or, at
least that was the case with the bit set I used ;-)

I must be missing something here, LOL. I use rail and stile router bits for
this operation and find that simply cutting the required extra pieces and
taking into consideration the length that will be lost and gained when
fitting the muntins and rails is the only difference in procedure other than
having to route both sides of the inner pieces.

As a hint, I do cut the inner pieces a tad longer and sneak up on the length
for a proper fit.