Wyatt wrote:

Since there was no way to get all 7 panels near 1/2" thickness, I'm
thinking about taking them all down to 1/4" and skipping the raised
panel. I did this to one board as a test and it looks good. But I'm
worried about 1/4" solid panels warping in the future.

That's what the rails and stiles are for.
_______________

Is this going to be a problem? If I do it again, I'm not going to
resaw and bookmatch. Instead I will just match boards as best as I
can and go for the full 1/2" thickness. I'm kind of new to panels in
doors, is 1/4" that much more likely to warp than 1/2"? Should I just
get 1/4" cherry veneered mdf and go with that?

That works too.

--
dadiOH
____________________________

dadiOH's dandies v3.06...
....a help file of info about MP3s, recording from
LP/cassette and tips & tricks on this and that.
Get it at http://mysite.verizon.net/xico