View Single Post
  #7   Report Post  
DaveM
 
Posts: n/a
Default Powering up an ATX PS ?

"Sam Goldwasser" wrote in message
...
writes:

I think CompUSA sells a PS tester. This gets by all of those wiring and
switch problems. It is only about $20.00


What more is there than jumpering the Power_Supply_On wire to ground with
a load on the output?

--- sam | Sci.Electronics.Repair FAQ:
http://www.repairfaq.org/
Repair | Main Table of Contents: http://www.repairfaq.org/REPAIR/
+Lasers | Sam's Laser FAQ: http://www.repairfaq.org/sam/lasersam.htm
| Mirror Sites: http://www.repairfaq.org/REPAIR/F_mirror.html

Important: Anything sent to the email address in the message header above
is
ignored unless my full name is included in the subject line. Or, you can
contact me via the Feedback Form in the FAQs.




That's pretty much all there is to those little cheapie testers... A
little box containing a minimal load, some LEDs that give a go//nogo
indication of all the voltages, a switch that lets you turn the PS on-off
from the box and an instruction sheet that was written by a Chinese
housewife and translated into English by a Russian schoolboy.
--
Dave M
MasonDG44 at comcast dot net (Just substitute the appropriate characters in
the address)

Never take a laxative and a sleeping pill at the same time!!