wrote in message
...
On Thu, 20 Oct 2005 07:03:44 -0400, "George" George@least wrote:


"Randy A" wrote in message
...
I am the new owner of a Delta DC-33 planer, and I am in the process of
changing the knives. After reading the manual, I am curious of the
adjustment of the outfeed roll. The manual states for outfeed roll to be
set at .020" on the left side of the roll, but .030" on the right side of
the roll. I would have expected both sides to be at the same height. Am
I
misinterpreting the instructions? If not, does anyone know the reason
for
the difference?


I suspect a misprint.

The RC-33 is set at .040 below the arc, though I suspect there have been
many changes since Invicta made the planer.




the literature the OP presented was very specific, mentioning it in
several places in ways that precluded misprint.

For those who can get any binaries on abpw ....