This sounds like a good candidate for loose tenon joints. Are you too far
along and too committed to integral tenon?

Steve

"Bruce Barnett" wrote in message
...
"Mike Reed" writes:

If the tenon might be the problem, then, cut a mortise-sized dado in
maybe a 3" length of stock and drag that along the length of the tenon
to see where there's interference.

I suppose you can glue up a scrap making sure it's the "official"
mortise dimensions. Might be easier than cutting a dado, if you can
wait for the glue to dry.

--
Sending unsolicited commercial e-mail to this account incurs a fee of
$500 per message, and acknowledges the legality of this contract.