Home |
Search |
Today's Posts |
|
Woodworking (rec.woodworking) Discussion forum covering all aspects of working with wood. All levels of expertise are encouraged to particiapte. |
Reply |
|
LinkBack | Thread Tools | Display Modes |
#1
|
|||
|
|||
DC Control Printed Board
Hi Group:
I bought a surplus GE motor with a PWM (Pulse Width Modulation) printed board. The board now causes the motor to vibrate and run rough, particularly noticable at low speed on my lathe. I've been able to prove the board is at fault, by trying a different board temporarily. Does any one have a spare board or know where to acquire one? Joe Yablonski -- Remove par from email address for replying |
#2
|
|||
|
|||
On Mon, 10 Jan 2005 20:26:21 GMT, golf wrote:
I bought a surplus GE motor with a PWM (Pulse Width Modulation) printed board. The board now causes the motor to vibrate and run rough, particularly noticable at low speed on my lathe. Try getting it repaired (probably not by GE). The usual failure mode is one of the output MOSFETs in the bridge circuit, which keeps the motor "running" but gives the vibration you describe. It's not a hard fault to detect, nor to repair - any reasonable electronics person should be able to sort it. |
#3
|
|||
|
|||
On Mon, 10 Jan 2005 15:13:49 -0700, Andy Dingley wrote
(in article ): On Mon, 10 Jan 2005 20:26:21 GMT, golf wrote: I bought a surplus GE motor with a PWM (Pulse Width Modulation) printed board. The board now causes the motor to vibrate and run rough, particularly noticable at low speed on my lathe. Try getting it repaired (probably not by GE). The usual failure mode is one of the output MOSFETs in the bridge circuit, which keeps the motor "running" but gives the vibration you describe. It's not a hard fault to detect, nor to repair - any reasonable electronics person should be able to sort it. Yep, the MOSFET (and freewheel diode) plus any electrolytics. -Bruce |
Reply |
Thread Tools | Search this Thread |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Forum | |||
DC Control Printed Board | Woodturning | |||
Carrier Gas Furnace (forced Aire) blow only cold air | Home Repair | |||
Kenmore Eliter dryer electronic control board repair | Electronics Repair | |||
Maytag Touchpad and Electronic Control Circuit Board Assembly | Home Repair | |||
Z80 control board / EPROM Programming | Electronics |