DIYbanter - Air powered glue applicator from Oct FWW

So far I have gotten no bites on my question about this glue applicator, so
I will provide some more info. It is a air pressure powered glue gun that
applies PVA adhesive. It is especially nice for times when you have a lot
of gluing to do and want to have a neat way of applying it. It is also a
nice way of getting glue into an area that would be hard to apply with a
regular glue bottle.

I have attached a link to a photo to show what it looks like. The assembly
in the photo is a 4 inch sched. 40 PVC pipe with a cap at the bottom and a
screw cleanout at the top. I tapped the side of the top of the tube for the
output of the regulator. The best thing so far to seal the spout is a
special bottle, filled with water, made from a ball jar (see photo). It
keeps the tube clear of dried glue and you just have to flush out the water
by pulling the trigger and waiting for the water to drain (followed by the
glue). It takes anywhere from 20 to 40 lbs to force the glue out at a
decent pace.

I have an aluminum hanger to hold the gun while I am gluing and an aluminum
support for the ball jar all clamped with a hose clamp. Although you can't
see it, I have a rubber grommet in the top of the ball jar that sort of
seals the glue gun barrel when I am not using the gun. The tip of the gun
is held in the water in the ball jar. I am hanging the assembly with a
simple wire hanger that is attached (along with the regulator) by another
hose clamp. I was looking for a simpler way of sealing the tip of the gun
to keep the glue from drying, but so far caplugs and other approaches have
limited success.

Any other improvement ideas would be welcome.

Here is the photo

http://img.photobucket.com/albums/v3...pplicator2.jpg