DIYbanter

DIYbanter (https://www.diybanter.com/)
-   Woodworking (https://www.diybanter.com/woodworking/)
-   -   Duck clean release blue tape (https://www.diybanter.com/woodworking/372986-duck-clean-release-blue-tape.html)

Len[_4_] July 29th 14 10:14 PM

Duck clean release blue tape
 
It's junk. It does not even stick to well itself! I put it over some door hinges to protect them while I was painting the door. The tape would not release after one day. I needed to use any means possible to get the paper off. Then mineral spirits to get the glue off the hinges.

The original blue tape is more expensive, releases well, and, is cheaper than the Duck brand you include the cost of your time.

My $.02

Len

Mike Marlow[_2_] July 29th 14 10:23 PM

Duck clean release blue tape
 
Len wrote:

It's junk. It does not even stick to well itself! I put it over
some door hinges to protect them while I was painting the door. The
tape would not release after one day. I needed to use any means
possible to get the paper off. Then mineral spirits to get the glue
off the hinges.


I've never used the stuff but that surprises me - a lot. Plain old masking
tape would behave better than that. I'm really quite surprised at within a
day it would not remove. It usually takes a lot of sun or heat or rain to
cause tapes to behave that way. Sounds like either a bad batch of tape or
that they have crossed the threshold in making the backer material too thin
and it's lost its strength in practical application.

--

-Mike-




Leon[_5_] July 30th 14 01:09 PM

Duck clean release blue tape
 
Len wrote:
It's junk. It does not even stick to well itself! I put it over some
door hinges to protect them while I was painting the door. The tape would
not release after one day. I needed to use any means possible to get the
paper off. Then mineral spirits to get the glue off the hinges.

The original blue tape is more expensive, releases well, and, is cheaper
than the Duck brand you include the cost of your time.

My $.02

Len


Ok, you have to pay attention to what the specs say. Duck blue tape
indicates that you can apply up to 14 days before painting. That's BEFORE
painting. Even Frog tape says to remove the tape before the paint dies.
Many of these painters tapes have an additive in the adhesive that reacts
with the paint to seal the edge and prevent seepage. If you wait until the
paint dries you will have more difficulty with removal. And or if the tape
was not flat against the object being masked paint can seep under the tape
and cause more severe removal issues.

EXT August 5th 14 07:17 PM

Duck clean release blue tape
 

"Leon" wrote in message
...
Len wrote:
It's junk. It does not even stick to well itself! I put it over some
door hinges to protect them while I was painting the door. The tape would
not release after one day. I needed to use any means possible to get the
paper off. Then mineral spirits to get the glue off the hinges.

The original blue tape is more expensive, releases well, and, is cheaper
than the Duck brand you include the cost of your time.

My $.02

Len


Ok, you have to pay attention to what the specs say. Duck blue tape
indicates that you can apply up to 14 days before painting. That's BEFORE
painting. Even Frog tape says to remove the tape before the paint dies.


I have never used Frog tape but it looks good in the commercials. But if
they want you to remove the tape BEFORE the paint dries, that is bad.
Handling tape with wet paint means paint on the hands and fingers and on
everything that you touch. It also means that to put two coats of paint,
which I normally do, I would have to remove the tape and then re-tape for
the second coat. That is not going to happen, I will rely on cutting in the
paint edge with a brush, a lot less work and cost than taping twice.


[email protected] August 5th 14 11:54 PM

Duck clean release blue tape
 
On Tue, 5 Aug 2014 14:17:42 -0400, "EXT"
wrote:


"Leon" wrote in message
...
Len wrote:
It's junk. It does not even stick to well itself! I put it over some
door hinges to protect them while I was painting the door. The tape would
not release after one day. I needed to use any means possible to get the
paper off. Then mineral spirits to get the glue off the hinges.

The original blue tape is more expensive, releases well, and, is cheaper
than the Duck brand you include the cost of your time.

My $.02

Len


Ok, you have to pay attention to what the specs say. Duck blue tape
indicates that you can apply up to 14 days before painting. That's BEFORE
painting. Even Frog tape says to remove the tape before the paint dies.


I have never used Frog tape but it looks good in the commercials. But if
they want you to remove the tape BEFORE the paint dries, that is bad.
Handling tape with wet paint means paint on the hands and fingers and on
everything that you touch. It also means that to put two coats of paint,
which I normally do, I would have to remove the tape and then re-tape for
the second coat. That is not going to happen, I will rely on cutting in the
paint edge with a brush, a lot less work and cost than taping twice.


I find that it's best to remove tape after the surface is fully set
but before the paint is fully cured. After the first day the chance
of things going bad go up quickly. Any second coats should be applied
well before this. I generally pull the tape the evening I paint as
I'm cleaning up.


Leon[_7_] August 6th 14 05:12 AM

Duck clean release blue tape
 
On 8/5/2014 1:17 PM, EXT wrote:

"Leon" wrote in message
...
Len wrote:
It's junk. It does not even stick to well itself! I put it over some
door hinges to protect them while I was painting the door. The tape
would
not release after one day. I needed to use any means possible to get
the
paper off. Then mineral spirits to get the glue off the hinges.

The original blue tape is more expensive, releases well, and, is cheaper
than the Duck brand you include the cost of your time.

My $.02

Len


Ok, you have to pay attention to what the specs say. Duck blue tape
indicates that you can apply up to 14 days before painting. That's
BEFORE
painting. Even Frog tape says to remove the tape before the paint dies.


I have never used Frog tape but it looks good in the commercials. But if
they want you to remove the tape BEFORE the paint dries, that is bad.
Handling tape with wet paint means paint on the hands and fingers and on
everything that you touch. It also means that to put two coats of paint,
which I normally do, I would have to remove the tape and then re-tape
for the second coat. That is not going to happen, I will rely on cutting
in the paint edge with a brush, a lot less work and cost than taping twice.


I have done my fair share of painting, probably 20+ complete home
interiors and I am not a painter.

I'll share a few tricks. If you wait for the paint to dry the tape will
take some with it, the paint needs to still be soft to some extent.
Experience will help you decide when to pull the tape.

A Quality paint will cover with one coat. So while cheaper paints are
cheaper than quality paints they cost you in time.
If it does not cover on the first coat you will know this before the
paint completely dries. The second coat is easy to apply when the paint
is still soft but not sticky.

As far as paint on your hands and fingers and everything you touch,
Don't touch anything but the tape and do nothing else until the tape is
completely removed. While this may sound like more work you have the
other choice of working on cleaning the tape off what it would not
release, as you have witnessed. Pull the tape when you can focus your
attention, even the pro's get paint on their hands.

In April we had the carpet removed from out staircase and had dark hard
wood treads and primed wood risers installed. The installer caulked
all cracks and joints. I followed up with a quality oil based simi-
gloss enamel on top of the caulk lines and the primed risers. I masked
the joints at the ends of the treads and risers and where each met the
other both on top of the tread and under the tread. The tape came off
with in 3 hours of me painting. No mess other that a bit of paint on my
hands. I started removing at the top and worked my way down. Because
the risers were still wet I held on to the ball of tape and descended
only one time, I did not want to risk kicking the risers. I immediately
wiped my hands with a rag and mineral spirits and then washed my hands.
If you are dealing with latex, just wash your hands.

And you also have the option of freehand cutting in, that is easy
around door jams and walls. Small spaces like a stair case, ;!) better
use tape.





Ed Pawlowski August 6th 14 02:11 PM

Duck clean release blue tape
 
On 8/6/2014 12:12 AM, Leon wrote:

I immediately
wiped my hands with a rag and mineral spirits and then washed my hands.
If you are dealing with latex, just wash your hands.


Twenty years ago I'd have done just that. Now I just toss the latex
gloves instead of handling chemicals.


Leon[_7_] August 6th 14 02:41 PM

Duck clean release blue tape
 
On 8/6/2014 8:11 AM, Ed Pawlowski wrote:
On 8/6/2014 12:12 AM, Leon wrote:

I immediately
wiped my hands with a rag and mineral spirits and then washed my hands.
If you are dealing with latex, just wash your hands.


Twenty years ago I'd have done just that. Now I just toss the latex
gloves instead of handling chemicals.



Hey you are smart! For some reason I wear the gloves when staining but
not with the painting..... too obvious I guess. LOL

Although in Houston my hands are swimming in sweat after 30 or so
minutes. After a day of painting I think I would have prune hands.

[email protected] August 6th 14 06:39 PM

Duck clean release blue tape
 
On Wed, 06 Aug 2014 09:11:34 -0400, Ed Pawlowski wrote:

On 8/6/2014 12:12 AM, Leon wrote:

I immediately
wiped my hands with a rag and mineral spirits and then washed my hands.
If you are dealing with latex, just wash your hands.


Twenty years ago I'd have done just that. Now I just toss the latex
gloves instead of handling chemicals.


For latex I rarely use gloves but use the $5/100 (on sale) HF nitrile
gloves for anything else.

Martin Eastburn August 31st 14 12:59 AM

Duck clean release blue tape
 
On 8/6/2014 12:39 PM, wrote:
On Wed, 06 Aug 2014 09:11:34 -0400, Ed Pawlowski wrote:

On 8/6/2014 12:12 AM, Leon wrote:

I immediately
wiped my hands with a rag and mineral spirits and then washed my hands.
If you are dealing with latex, just wash your hands.


Twenty years ago I'd have done just that. Now I just toss the latex
gloves instead of handling chemicals.


For latex I rarely use gloves but use the $5/100 (on sale) HF nitrile
gloves for anything else.

I buy a box of nitrile for my size of hands and my beloved. Neither of
us need some of the chemicals we deal with now days. Paint to be
included. Sometimes it is bio grade. One never knows what flows or
grows in 'wild' water. Might be micro flukes or worms.

Martin


All times are GMT +1. The time now is 09:01 AM.

Powered by vBulletin® Copyright ©2000 - 2024, Jelsoft Enterprises Ltd.
Copyright ©2004 - 2014 DIYbanter