Unisaw R/I motor rotation direction question
 

Hello All:

I have an older Unisaw with a repulsion/induction motor. These motors have
an adjustment for the brush location which should change the direction of
rotation. On my motor, that adjustment has no effect and the motor runs in
the wrong direction no matter what I do.

Can any of you suggest what might be causing this and how I could fix it?

Thanks,

Jim

Unisaw R/I motor rotation direction question
 

Jim Martin wrote:
Can any of you suggest what might be causing this and how I could fix it?


Take it to a competent motor man.

UA100

Unisaw R/I motor rotation direction question
 

"Unisaw A100" wrote in message
...
Take it to a competent motor man.

Hi Keith:

Turns out that I had to rotate the brush holder WAY past the indicator mark.
Runs great now and does not have that acceleration lag we talked about last
week. That lag was apparently due to the fact that the motor was wired for
220 but the plug was a 110. Not sure how your saw is set up but if you have
that lag you might want to check the wiring. Anyway, once I wired it up
properly it insisted on running the wrong way till Rob Peterson recommended
rotating the brushes much further than the idicator marks.

The $200 Unisaw (well now I guess it has added up to a little over $500 with
$50 worth of bearings, a $210 fence, and a $47 top) is now ready to go to
work for another half century.

Cheers,

Jim

Cheers,

Jim