Vise jaws
I just finished a couple of vise jaws and was wondering what opinions
you all had about lining them with leather. My original idea was to put wrap a 1.75" maple core with a couple of 1/8" skins on either side for balance. Then I could plane off and replace just the inside face when it gets beaten up. But I sorta like the idea of having something with a little give to it, for a little more grip with a little less clamping pressure. Has anyone ever tried EPDM on their vise jaws? Lastly, if I do just leave them as is (2" thick hard maple), should I put any type of finish on them? I'd probably rub a little on the top edge just in case glue got on them, but what about the backs and faces? I used polymerized linseed oil and beeswax for the bench, so I'd probably not want to use that (I think...too slippery?) Time for some googling... JP |
Vise jaws
vise jaws are a consumable. don't get too hung up on making them
special. make several sets when you make any, to save steps and to give you some to cut notches in/ screw things to/ mangle by grabbing tightly to rude objects etc. make a few out of soft pine for grabbing things that have surfaces that want a forgiving but firm grip. make a set with sandpaper faces and a set with rubber faces. make a set with hardwood faces scraped smooth and finished with oil. make a set with brass faces. |
Vise jaws
wrote in message set with sandpaper faces and a set with rubber faces. make a set with hardwood faces scraped smooth and finished with oil. make a set with brass faces. And if he doesn't want to make some of those types, he can buy them. http://www.leevalley.com/wood/page.a...25&cat=1,41659 |
Vise jaws
|
Vise jaws
On Oct 3, 2:27 am, wrote:
vise jaws are a consumable. don't get too hung up on making them special. make several sets when you make any, to save steps and to give you some to cut notches in/ screw things to/ mangle by grabbing tightly to rude objects etc. make a few out of soft pine for grabbing things that have surfaces that want a forgiving but firm grip. make a set with sandpaper faces and a set with rubber faces. make a set with hardwood faces scraped smooth and finished with oil. make a set with brass faces. These jaws are 2x6x33" hard maple, so I'm not likely to be making too many of them unless the boss decides to be generous with some long cutoffs again! I think I'm going to go with leather. I like the look and I believe it will do what I want. For other stuff I can use my metal vise or the smaller face vise on the other bench. These are going to be for my "good" bench. Thanks for the replies all. JP |
All times are GMT +1. The time now is 03:33 PM. |
Powered by vBulletin® Copyright ©2000 - 2024, Jelsoft Enterprises Ltd.
Copyright ©2004 - 2014 DIYbanter