Just received my new Osborne miter guage
 

There has been a lot of criticism from mainly 2 persons about this gauge. I
just got my new Osborne Model #50-EB3 miter gauge Saturday. I assembled it
and calibrated it and then started using it. I am very pleased with it's
performance. It is a very solid miter gauge and is a little on the heavy
side. Perhaps in the past this gauge may have left something to be desired,
but I don't find those digs against it to be warranted now. The gauge is
now manufactured by Excalibur, a division of General International of
Canada.
Regardless of what Leon and the rest say about it I will not change my raves
about it.

Just received my new Osborne miter guage
 

On Apr 22, 8:21 pm, "Will" wrote:
There has been a lot of criticism from mainly 2 persons about this gauge. I
just got my new Osborne Model #50-EB3 miter gauge Saturday. I assembled it
and calibrated it and then started using it. I am very pleased with it's
performance. It is a very solid miter gauge and is a little on the heavy
side. Perhaps in the past this gauge may have left something to be desired,
but I don't find those digs against it to be warranted now. The gauge is
now manufactured by Excalibur, a division of General International of
Canada.
Regardless of what Leon and the rest say about it I will not change my raves
about it.

If the gauge has been beefed up to address the main 45 degree issue
Leon and the rest say exists, then there is nothing more to be said.
The issue(s) were based on facts, not opinion. If it is fixed, then
you should rave about it.

Just received my new Osborne miter guage
 

"Will" wrote in message
m...
There has been a lot of criticism from mainly 2 persons about this gauge.
I just got my new Osborne Model #50-EB3 miter gauge Saturday. I assembled
it and calibrated it and then started using it. I am very pleased with
it's performance. It is a very solid miter gauge and is a little on the
heavy side. Perhaps in the past this gauge may have left something to be
desired, but I don't find those digs against it to be warranted now. The
gauge is now manufactured by Excalibur, a division of General
International of Canada.
Regardless of what Leon and the rest say about it I will not change my
raves about it.




Well Will, if yours has a beefier telescoping degree shaft then perhaps they
have fixed the problem. I hope you stay safe and whack a bucha of boards
with the gauge.