Woodworking (rec.woodworking) Discussion forum covering all aspects of working with wood. All levels of expertise are encouraged to particiapte.

Reply
 
LinkBack Thread Tools Search this Thread Display Modes
  #1   Report Post  
Dirty Bob
 
Posts: n/a
Default Does anyone still make tape measure refill tapes?

Seems to me that refill tapes for tape measures used to be available. I say
used to be, because I've been shopping around when I get into town. Nobody
seems to have them, and the general consensus is that they aren't available
anymore. Guess I'll have to spring for the $15 to $20 for a whole new tape.
Unless, that is, someone here can enlighten me as to a source for these
things.

Hopefully:

Bob

--
re. email: I have no equal.


  #2   Report Post  
 
Posts: n/a
Default Does anyone still make tape measure refill tapes?

On Sat, 9 Aug 2003 14:04:33 -0700, "Dirty Bob"
wrote:

Seems to me that refill tapes for tape measures used to be available. I say
used to be, because I've been shopping around when I get into town. Nobody
seems to have them, and the general consensus is that they aren't available
anymore. Guess I'll have to spring for the $15 to $20 for a whole new tape.
Unless, that is, someone here can enlighten me as to a source for these
things.

Hopefully:

Bob


try sears. they used to have em. but then everyone else used to have
em too!!!!!!!! good luck. skeez
  #3   Report Post  
Mark & Shauna
 
Posts: n/a
Default Does anyone still make tape measure refill tapes?

We are in the building trade and used to buy refills (we exclusively
use 25 and 30 foot chrome stanley's) but when the refills began to cost
as much as a tape they started to disapear (and of course we stopped
buying). It used to be that a 25' chrome stanley would cost about 15-17
dollars depending on how you bought them. The refills were then about
10.00 and we felt it worthwhile to buy them. Now however, when we buy
the tapes by the box (4pcs at a time) we pay just over 8.00 for a 25'
tape and a bit more for a 30. I dont think they could sell you the
refill for what it would be worth.
We have used a lot of different tapes and have personally found these
the best for us. We go through a lot of them but even for the individual
buying 4 at a time is not a big deal at under 40 bucks. For the average
joe that may be a year or more worth of tapes. I seem to buy a couple
boxes every couple months hehe...
The sad part now is that the blades are usually not what fails for us,
its the recoil, which is now a sealed unit and cant be repaired. Perhaps
they should sell those!

Mark

Dirty Bob wrote:
Seems to me that refill tapes for tape measures used to be available. I say
used to be, because I've been shopping around when I get into town. Nobody
seems to have them, and the general consensus is that they aren't available
anymore. Guess I'll have to spring for the $15 to $20 for a whole new tape.
Unless, that is, someone here can enlighten me as to a source for these
things.

Hopefully:

Bob


  #4   Report Post  
Wilson Lamb
 
Posts: n/a
Default Does anyone still make tape measure refill tapes?

Sears sell a nice refillable tape.
HD will give you a new Stanley for an old one.
Wilson
"Dirty Bob" wrote in message
...
Seems to me that refill tapes for tape measures used to be available. I

say
used to be, because I've been shopping around when I get into town.

Nobody
seems to have them, and the general consensus is that they aren't

available
anymore. Guess I'll have to spring for the $15 to $20 for a whole new

tape.
Unless, that is, someone here can enlighten me as to a source for these
things.

Hopefully:

Bob

--
re. email: I have no equal.




  #5   Report Post  
Gerald Ross
 
Posts: n/a
Default Does anyone still make tape measure refill tapes?

Saw some 25' ones in WalMart this week, wide tape, with rubber cover.
$1.95 for the whole shebang. With disposable tapes like that, why buy
just a part for one.

Dirty Bob wrote:

Seems to me that refill tapes for tape measures used to be available. I say
used to be, because I've been shopping around when I get into town. Nobody
seems to have them, and the general consensus is that they aren't available
anymore. Guess I'll have to spring for the $15 to $20 for a whole new tape.
Unless, that is, someone here can enlighten me as to a source for these
things.

Hopefully:

Bob

--
re. email: I have no equal.


--

Gerald Ross
Cochran, GA
............................................
Is there life before coffee?


-----= Posted via Newsfeeds.Com, Uncensored Usenet News =-----
http://www.newsfeeds.com - The #1 Newsgroup Service in the World!
-----== Over 80,000 Newsgroups - 16 Different Servers! =-----


  #6   Report Post  
patrick mitchel
 
Posts: n/a
Default Does anyone still make tape measure refill tapes?


Gerald Ross wrote in message
...
Saw some 25' ones in WalMart this week, wide tape, with rubber cover.
$1.95 for the whole shebang. With disposable tapes like that, why buy
just a part for one.

Dirty Bob wrote:

Seems to me that refill tapes for tape measures used to be available. I

say
used to be, because I've been shopping around when I get into town.

Nobody
seems to have them, and the general consensus is that they aren't

available
anymore. Guess I'll have to spring for the $15 to $20 for a whole new

tape.
Unless, that is, someone here can enlighten me as to a source for these
things.

Hopefully:

Bob

--
re. email: I have no equal.


--

Gerald Ross
Cochran, GA
...........................................
Is there life before coffee?


-----= Posted via Newsfeeds.Com, Uncensored Usenet News =-----
http://www.newsfeeds.com - The #1 Newsgroup Service in the World!
-----== Over 80,000 Newsgroups - 16 Different Servers! =-----


Mcmaster-carr catalog #104 p1725 has the tapes and rep.blades - the
replacement tapes are 1/2 to 2/3 the cost of the original.... By the way-
the last cheapie i bought was a 1/4" out in 20'.Not bad but not accurate
when there is one guy taking the measure and nuther doing the cutting. pat


  #7   Report Post  
Mark & Shauna
 
Posts: n/a
Default Does anyone still make tape measure refill tapes?

patrick mitchel wrote:
By the way-
the last cheapie i bought was a 1/4" out in 20'.Not bad but not accurate
when there is one guy taking the measure and nuther doing the cutting. pat



Actually, this is true with all tapes. When you have two people working
off each other you HAVE to start first by both hooking your tapes and
run them out to the longest measure and see how far off they are. This
is one reason we would wind up with many many tapes as if they dont
match when you are doing critical work you wind up getting two new ones
out of the trailer (put them back when and save them for two man
operations). If they are only off by a little and the job isnt too
critical you can bend the tips a bit to true them up.

The tip (the rivets in the slider) is where they wear out but a slight
bend in the tip can true one up if the slider isnt really badly worn.
Just remember to always bend the one that is measuring too long, that
way the tip will still grab and not slip.

Mark

  #8   Report Post  
Katherine
 
Posts: n/a
Default Does anyone still make tape measure refill tapes?

I work at Home Depot (most often in the Tool Corral) and have never
seen a tape measure refill. Stanley used to give a lifetime warranty
on tapes, but no longer. Since Stanley doesn't offer the lifetime
warranty, neither does HD and depends how old the tape is, if HD will
replace it.

Good luck
  #9   Report Post  
Larry Jaques
 
Posts: n/a
Default Does anyone still make tape measure refill tapes?

On Sat, 09 Aug 2003 21:22:25 -0400, Gerald Ross
pixelated:

Saw some 25' ones in WalMart this week, wide tape, with rubber cover.
$1.95 for the whole shebang. With disposable tapes like that, why buy
just a part for one.


They're labeled in Chinese inches.
Whoda thunk it?


---
Annoy a politician: Be trustworthy, faithful, and honest!
---
http://www.diversify.com Comprehensive Website Development
  #10   Report Post  
Ernie Jurick
 
Posts: n/a
Default Does anyone still make tape measure refill tapes?


"Katherine" wrote in message
om...
I work at Home Depot (most often in the Tool Corral) and have never
seen a tape measure refill. Stanley used to give a lifetime warranty
on tapes, but no longer.


My 35-year-old Stanley 12' gave up the ghost on Friday. I was brokenhearted
to learn that the free replacement policy was no longer in effect. If the
new one lasts 35 years, however, I will be more than happy, and probably
long dead by the time it gives out.
-- Ernie




  #11   Report Post  
William E. Prisavage
 
Posts: n/a
Default Does anyone still make tape measure refill tapes?

Stanley used to warranty the rivets,I'm not joking.Drill one of the rivets
out and they had to take it back.
DAMHIKT
"Ernie Jurick" wrote in message
...

"Katherine" wrote in message
om...
I work at Home Depot (most often in the Tool Corral) and have never
seen a tape measure refill. Stanley used to give a lifetime warranty
on tapes, but no longer.


My 35-year-old Stanley 12' gave up the ghost on Friday. I was

brokenhearted
to learn that the free replacement policy was no longer in effect. If the
new one lasts 35 years, however, I will be more than happy, and probably
long dead by the time it gives out.
-- Ernie




  #12   Report Post  
John Thompson
 
Posts: n/a
Default Does anyone still make tape measure refill tapes?

I just replaced the tape on my Stanley 1"x25' tape today. Somehow, the
tape around the hook at the rivets had started to tear, and I let it
snap back too hard yesterday, and it ripped the hook off with a piece of
the tape. Didn't think anyone would carry replacement tapes anymore, so
I was planning to buy a new 25' measure today. They were out of the
silver bodied ones like I have, but surprise!, there were some
replacement tapes. Took some work to get the spring would up right, but
now I've got a like new tape in a beat up body (the tape measure, not
mine!).

John

  #13   Report Post  
Mark & Shauna
 
Posts: n/a
Default Does anyone still make tape measure refill tapes?

William E. Prisavage wrote:
Stanley used to warranty the rivets,I'm not joking.Drill one of the rivets
out and they had to take it back.
DAMHIKT



Ahh yet another contributor to the downfall of all things quality. Now,
just because some idiot who owns a drill and a drill bit wants a new
tape they can F*ck an honest and quality manufacturer at will. The
American conscience has no bounds. Its a scary world this one you are
building.

Sweet dreams... hope you dont have kids,

Mark

  #14   Report Post  
Dirty Bob
 
Posts: n/a
Default Does anyone still make tape measure refill tapes?

And, who, pray tell, were "they". That's what I'm looking for!

--



  #15   Report Post  
Lew Hodgett
 
Posts: n/a
Default Does anyone still make tape measure refill tapes?


"Dirty Bob" writes:

And, who, pray tell, were "they". That's what I'm looking for!


Probably cost more than a new tape complete which is why you don't very
often find them.


--
Lew

S/A: Challenge, The Bullet Proof Boat, (Under Construction in the Southland)
Visit: http://home.earthlink.net/~lewhodgett for Pictures


Reply
Thread Tools Search this Thread
Search this Thread:

Advanced Search
Display Modes

Posting Rules

Smilies are On
[IMG] code is On
HTML code is Off
Trackbacks are On
Pingbacks are On
Refbacks are On


Similar Threads
Thread Thread Starter Forum Replies Last Post
Tom Gardner: another tape measure Joel Corwith Metalworking 2 November 28th 03 05:38 AM
Reading a tape measure...again Tom Gardner Metalworking 46 November 11th 03 04:19 PM
This can make you some extra cash, check it out. Nick Burns Woodworking 1 July 15th 03 03:55 AM
Knife Steel FAQ updated Gunner Metalworking 9 June 26th 03 11:11 PM


All times are GMT +1. The time now is 05:00 PM.

Powered by vBulletin® Copyright ©2000 - 2024, Jelsoft Enterprises Ltd.
Copyright ©2004-2024 DIYbanter.
The comments are property of their posters.
 

About Us

"It's about DIY & home improvement"