v-tongue and grove router bit
 

I have been searching for something that may not be made. Have seen
lots of v-tongue and groove router bits on the Internet but most of
them do not tell you what thickness boards they are for. Does anybody
know if an adjustable v-tongue and groove bit is available for boards
from 1/2" to 1"? Thanks.

Vic

v-tongue and grove router bit
 

Have seen (southeasttool.com) wedge T&G from 1/2 to 9/8 stock.
Have also seen some Chinese plywood vee cutters as you suggest (no
source), with cutting cpability to 7/8.

Do not know about adjustables but would check Amana on that, probably
the largest inventory in the world.

http://www.patwarner.com (Routers)
************************************************** **********
Vic wrote:
I have been searching for something that may not be made. Have seen
lots of v-tongue and groove router bits on the Internet but most of
them do not tell you what thickness boards they are for. Does anybody
know if an adjustable v-tongue and groove bit is available for boards
from 1/2" to 1"? Thanks.

Vic