new infill drawing what do you think?
 

Here are what I hope to be the final drawings of my new infill body.
It is 9” long and 2.5” tall at the top. This drawing is for a 2”
ironed plane but I will have one for a 2.5” too. The pics show bedding
angles of 45,47,50,55 and 60. The sides are 3/16” brass and the sole
¼” steel.

Let em know if I goofed on the dovetails. They were a bit of a pain to
get the mouth where I wanted it (about 1/3 back). I liked the mouth in
them idle but it caused problems with holding the plane on my other
infills.

http://www.knight-toolworks.com/web_...cs/infillf.jpg
http://www.knight-toolworks.com/web_...cs/infillb.jpg
http://www.knight-toolworks.com/web_...cs/infillp.jpg

new infill drawing what do you think?
 

your drawing shows the dovetails undercut. did you do that
intentionally, perhaps to leave room for peening or something?

new infill drawing what do you think?
 

On 17 May 2006 09:37:50 -0700, wrote:

your drawing shows the dovetails undercut. did you do that
intentionally, perhaps to leave room for peening or something?

right but it may be more then normal. not sure yet.