misc
1 Attachment(s)
misc
|
misc
David wrote:
misc Nice work!!! Totally dig the layout... Lot of plottin' and plannin', I'd bet! Did you turn those legs using your lathe duplicator? Looks like pattern 1 legs... Would you give up more detail on that set up? More pix and such Plz????? All very impressive! TIA |
misc
3 Attachment(s)
TIA
The coffee table legs did come from using the duplicator. The hard part is finding the plate that the router attaches to with the steel rod. The plate travels back and forth on the stee rod. The duplicator was made with AutoCad but could be made with pencil and paper. The pivot point is were the rod attaches to the router plate then it's just line projection from there. The 1/4" steel pin attaches to the front of the router plate and the router bit is a straight 1/4" router bit. The pin follows the sheet metal pattern. Hope this helps. Dave |
All times are GMT +1. The time now is 12:54 PM. |
Powered by vBulletin® Copyright ©2000 - 2024, Jelsoft Enterprises Ltd.
Copyright ©2004 - 2014 DIYbanter