old cedar - bowl
 

The bowl is not old, but the cedar is. The wood is part of one of the posts
which supported a 110 year old house SWMBO and I dismantled last year.

The posts were set about 4 to 5 feet deep in red plastic clay which is under
the part of town I live in. The wood was soaking wet when it was pulled from
the ground and the heart wood was gone. The remaining wood seemed pretty
sound and was stained somewhat, from its time in the ground.

I have not turned anything quite this soft, before, and was not too sure what
to expect. Long curls of wet wood streamed from the gouge, and this was just
too fun. And messy.

Rough turned to about 3/4 inch thickness, I set the bowl aside until this
winter to finish. I just finished it the other night, and after sanding I
gave it a coat inside and out,of water-soluble clear poly. The next day I
sanded again, as the water had raised the end grain a lot.

There is a fine network of checking in the wood. I noticed the cross-grain
character is quite brittle and resulted in significant shallow fracture
rather than clean cutting in the end-grain portions of the bowl, maybe 5% of
the end-grain area. I was taking very fine cuts when doing the finish turning
on this project and had no grabs or dammits. Final sanding after the coat of
poly was 400 grit, and then buffed out with Beall's ball bowl buffs and a
very light touch of wax on the 3rd buff. (my first buffing effort, and I am
very pleased with the "naked" finish)

Overall I am happy with the project, but am now wondering about what is
usually done to the wood when it is so soft, to prevent the kinds of surface
flaws I got in the end grain. I am thinking that spalted wood projects *must*
use something to hold the wood together under the stresses of spinning and
cutting and sanding. What?

pics on Flickr at
http://www.flickr.com/photos/55616ga...7628813701215/

look for a reference to cedar bowl

tom koehler

--
I will find a way or make one.

old cedar - bowl
 

In article . net, tom
koehler wrote:

Overall I am happy with the project, but am now wondering about what is
usually done to the wood when it is so soft, to prevent the kinds of surface
flaws I got in the end grain. I am thinking that spalted wood projects *must*
use something to hold the wood together under the stresses of spinning and
cutting and sanding. What?

I've used thin CA glue, but make sure you have good ventilation, as it
can give off nasty fumes.

--
Woodworking and more at http://www.woodenwabbits.com

old cedar - bowl
 

On 1/10/2012 2:27 PM, Dave Balderstone wrote:
In iernet.net, tom
id wrote:

Overall I am happy with the project, but am now wondering about what is
usually done to the wood when it is so soft, to prevent the kinds of surface
flaws I got in the end grain. I am thinking that spalted wood projects *must*
use something to hold the wood together under the stresses of spinning and
cutting and sanding. What?

I've used thin CA glue, but make sure you have good ventilation, as it
can give off nasty fumes.


as above - just buy a quart or two of CA glue and slather it on once you
are close to the shape you want - the proteins in the rot seem to
catalize the CA so it will fume and sputter, so apply it outside. I
really like the look of the rotten wood.