DIYbanter

DIYbanter (https://www.diybanter.com/)
-   Woodturning (https://www.diybanter.com/woodturning/)
-   -   Speaking about chainsaws... (https://www.diybanter.com/woodturning/217796-speaking-about-chainsaws.html)

Bart V[_2_] October 17th 07 02:38 PM

Speaking about chainsaws...
 
I have a Poulan, although the sticker says Patriot, that decided to
stop oiling the bar. It used to take 1 tank of bar oil per tank of gas
but now it just desn't use any bar oil at all. I looked to see if
there was anything I can unclog or whatever but no such luck.
This saw uses a little oil pump, it's not a gravity fed oiler, and
according to a repair guy this is real common for them Poulans. All in
all there's probably less than 24 hours of operation on this thing. A
friend replaced the oil with gas to see if it would flush itself clean
that didn't work either.
Any other tricks or perhaps suggestions for a low tech way of making
it a gravity fed set up?
Thanks,
Bart.
-
**botox treatments: taxidermy on the living**

Email replies via: www.haruteq.com/contact.htm
awesome banjo bridges, tabs, stained glass:
=== www.haruteq.com ===

Darrell Feltmate October 18th 07 03:25 AM

Speaking about chainsaws...
 
Chain saw with no bar oil equals a blued bar, i.e. ruined and likely the
chain as well. Do not run the saw until the oiler is fixed. Should there nto
be a warranty for less than 24 hours use?

--
God bless and safe turning
Darrell Feltmate
Truro, NS Canada
http://aroundthewoods.com
http://roundopinions.blogspot.com
"Bart V" wrote in message
...
I have a Poulan, although the sticker says Patriot, that decided to
stop oiling the bar. It used to take 1 tank of bar oil per tank of gas
but now it just desn't use any bar oil at all. I looked to see if
there was anything I can unclog or whatever but no such luck.
This saw uses a little oil pump, it's not a gravity fed oiler, and
according to a repair guy this is real common for them Poulans. All in
all there's probably less than 24 hours of operation on this thing. A
friend replaced the oil with gas to see if it would flush itself clean
that didn't work either.
Any other tricks or perhaps suggestions for a low tech way of making
it a gravity fed set up?
Thanks,
Bart.
-
**botox treatments: taxidermy on the living**

Email replies via: www.haruteq.com/contact.htm
awesome banjo bridges, tabs, stained glass:
=== www.haruteq.com ===





All times are GMT +1. The time now is 01:01 PM.

Powered by vBulletin® Copyright ©2000 - 2024, Jelsoft Enterprises Ltd.
Copyright ©2004 - 2014 DIYbanter