fa: GAST pump (should be OK for Vacuum chuck use)
normally, when I run across vacuum pumps, I test them, repair them and
offer them for sale via my web page but right now I'm drowning in stuff and don't have time to test this pump - it is a GAST rotary vane pump designed to be driven by a 1/4 HP 1750 RPM motor, I've put all the specs and info into the e-bay listing below. I've also set the starting price pretty low, but please only bid on it if you have the mechanical ability to put a pulley or coupler on it and connect it to a motor, and if you can install a service kit if it needs it - if you can do that then there is a good chance you will get an excellent price on a GAST pump. Note that I am not offering this through my web because I don't want to sell something through my web site that I haven't tested and know is good - this is untested. This is a pressure pump, not a vacuum pump, but in my experience, either type will deliver adequate vacuum for wood turning use as a vac chuck, and the specs say 4CFM flow, which is plenty for our use. here's the link http://cgi.ebay.com/ws/eBayISAPI.dll...tem=7613180262 Bill www.wbnoble.com to contact me, do not reply to this message, instead correct this address and use it will iam_ b_ No ble at msn daught com *** Posted via a free Usenet account from http://www.teranews.com *** |
All times are GMT +1. The time now is 08:05 PM. |
Powered by vBulletin® Copyright ©2000 - 2024, Jelsoft Enterprises Ltd.
Copyright ©2004 - 2014 DIYbanter