Question. can the supernova II do 1 1/2 x 8 tpi ?
 

Is there an adapter available for Oneway or Spernova II chucks that supports
1 1/2 x 8 tpi.

Thank you, Ed

"Eddie" wrote:

Is there an adapter available for Oneway or Spernova II chucks that
supports 1 1/2 x 8 tpi.

Thank you, Ed




Looks like Teknatool support direct threading only in that size:

http://www.teknatool.com/products/Ch...the%20Spindle%
20Thread.pdf

You may want to drop them an e-mail to be su

In article . net, "Eddie" wrote:
Is there an adapter available for Oneway or Spernova II chucks that supports
1 1/2 x 8 tpi.

Would a Stronghold insert work for you?
http://www.woodturnerscatalog.com/cg...n&key=130-3600

--
Regards,
Doug Miller (alphageek at milmac dot com)

Nobody ever left footprints in the sands of time by sitting on his butt.
And who wants to leave buttprints in the sands of time?

Why don't you look at www.oneway.ca and find out?

Bill

Eddie wrote:
Is there an adapter available for Oneway or Spernova II chucks that supports
1 1/2 x 8 tpi.

Thank you, Ed

I have a 1 1/2" spindle @ 6TPI and there are few adaptors due to the
diameter (firstly) and in my case then the 6TPI. I think it is
necessary to have the thread cut into the chuck. The downside of this
is that you will have to have a special engineering job done should
you ever want to use that chuck on any other spindle - no "commercial"
adaptor would be available to reduce from yoru 1 1/2" x 8TPI to a
smaller size.

Another option, if you don't have he Supernova, is to check sources in
the UK. I think I noticed some companies providing this size adaptor
there.

You could also check Vicmarc, but it would need to be the larger
chuck, again because of the 1 1/2" diameter.

Good luck,
Alan

Hi Eddy
Check the Oneway site and see for your self.

Have fun and take care
Leo Van Der Loo

http://www.oneway.on.ca/chucks/adaptors.htm

Eddie wrote:
Is there an adapter available for Oneway or Spernova II chucks that supports
1 1/2 x 8 tpi.

Thank you, Ed

Hi there,

I know that Sorby make an adapter for a nova chuck with an 11/2" by 6
tpi thread. I bought one so i could use my old nova chuck. Cost arround
=8035 at the time. They may also make one for 11/2" by 8. The 6tpi one
is the common pitch for that size of shaft in the UK and 8tpi in the
USA

Fran
Eddie wrote:
Is there an adapter available for Oneway or Spernova II chucks that
supports
1 1/2 x 8 tpi.
=20
Thank you, Ed

Leo Van Der Loo wrote in
:

Hi Eddy
Check the Oneway site and see for your self.

Have fun and take care
Leo Van Der Loo

http://www.oneway.on.ca/chucks/adaptors.htm

Eddie wrote:
Is there an adapter available for Oneway or Spernova II chucks that
supports 1 1/2 x 8 tpi.

Thank you, Ed

http://www.teknatool.com/products/Ch...ck_Inserts.htm