Concealed wiring and c/h pipes in a new conservatory
 

I won't bore the group with the hassle involved in getting this far, but
suffice it to say I have had to find another manufacturer to fit a conservatory
on the new base constructed by another one.

To minimise cost, I am fitting the new rad and doing the electrics - quite
happy with that. But how best to fix and conceal the wiring and 10mm c/h pipes
on a wall which the new people are going to plaster when the plastic bit is
finished?

In message , Paper2002AD
writes
I won't bore the group with the hassle involved in getting this far, but
suffice it to say I have had to find another manufacturer to fit a conservatory
on the new base constructed by another one.

To minimise cost, I am fitting the new rad and doing the electrics - quite
happy with that. But how best to fix and conceal the wiring and 10mm c/h pipes
on a wall which the new people are going to plaster when the plastic bit is
finished?

Just had ours done - they ran the c/h pipes in a groove cut in the
breeze blocks along the floor (covered by skirting). The electrics they
put behind galvanised steel runners and plastered over them.

--
Mike Buckley
RD350LC2
http://www.toastyhamster.freeserve.co.uk
BONY#38

But how best to fix and conceal the wiring and 10mm c/h pipes on a wall
which the new people are going to plaster when the plastic bit is
finished?

Cable clips and pipe clips? Electrical cable and 10mm microbore should be
easy enough to be covered directly by the bonding without needing chasing
into the brickwork. Make sure you check this with them first, though. They
may be planning to dot/dab dryline the wall rather than wet plaster.

Christian.