Monobloc Tap tails
How are you supposed to tighten them into the recesessed body of the tap?
Is it enough to just hand tighten them as they rely on an "O" ring? |
Monobloc Tap tails
In article ,
JohnP wrote: How are you supposed to tighten them into the recesessed body of the tap? Is it enough to just hand tighten them as they rely on an "O" ring? Fitted one here recently. Instructions said finger tight. -- *Growing old is inevitable, growing up is optional * Dave Plowman London SW To e-mail, change noise into sound. |
Monobloc Tap tails
On 05/03/2021 15:00, Dave Plowman (News) wrote:
In article , JohnP wrote: How are you supposed to tighten them into the recesessed body of the tap? Is it enough to just hand tighten them as they rely on an "O" ring? Fitted one here recently. Instructions said finger tight. Yeah, just done one, i'm not keen but i've done a few and had no failures. (Tempting fate by typing that?) |
Monobloc Tap tails
On 05/03/2021 15:42, R D S wrote:
On 05/03/2021 15:00, Dave Plowman (News) wrote: In article , Â*Â*Â* JohnP wrote: How are you supposed to tighten them into the recesessed body of the tap? Is it enough to just hand tighten them as they rely on an "O" ring? Fitted one here recently. Instructions said finger tight. Yeah, just done one, i'm not keen but i've done a few and had no failures. (Tempting fate by typing that?) I do up finger tight then nip up 1/4 turn with gas pliers |
Monobloc Tap tails
On 05/03/2021 14:58, JohnP wrote:
How are you supposed to tighten them into the recesessed body of the tap? Is it enough to just hand tighten them as they rely on an "O" ring? Hand tight is good enough to get a seal - a tiny bit more will also prevent any danger of it unscrewing itself accidentally while installing it. -- Cheers, John. /================================================== ===============\ | Internode Ltd - http://www.internode.co.uk | |-----------------------------------------------------------------| | John Rumm - john(at)internode(dot)co(dot)uk | \================================================= ================/ |
All times are GMT +1. The time now is 08:00 PM. |
Powered by vBulletin® Copyright ©2000 - 2024, Jelsoft Enterprises Ltd.
Copyright ©2004 - 2014 DIYbanter