Cistern Siphon issue
 

I have a couple of concealed slimline cisterns.
They have started to leak water into WC, this is 100% not down the
overflow pipe, as water level is well below that.
Took it out cleaned all €¦ still the same (or worse if anything) €¦. From
empty the infill €˜torbeck type starts filling, all is fine until
around 50mm deep .. and the water starts to leak €¦. Assuming that the
bottom €˜main seal is OK, as nothing gets past that initially, only
leaks when it get in over the float, so my logic is that is must be
getting past the inner seal.

Are these spares items ?
The main seal aprox 66 OD and 48 ID has No. 14.11.29 1 DAL
The inner seal aprox 48 OD and 30 ID has No. 14.11.30 8 DAL

Picture shows siphon, and the seals in the lower picture.
http://www.mediafire.com/file/p7yqjk...iphon.pdf/file

Cistern Siphon issue
 

rick wrote:

Picture shows siphon, and the seals in the lower picture.
http://www.mediafire.com/file/p7yqjk...iphon.pdf/file

Looks like you can by the bottom bit for £7
https://www.showerspares.com/search/grohe_dal_discharge_piston_43544_000

Or the whole thing for £16
https://www.showerspares.com/search/grohe_dal_single_flush_valve_assembly_42137_000

Cistern Siphon issue
 

On 06/10/2019 17:22, Andy Burns wrote:
rick wrote:

Picture shows siphon, and the seals in the lower picture.
http://www.mediafire.com/file/p7yqjk...iphon.pdf/file

Looks like you can by the bottom bit for £7
https://www.showerspares.com/search/grohe_dal_discharge_piston_43544_000

Or the whole thing for £16
https://www.showerspares.com/search/grohe_dal_single_flush_valve_assembly_42137_000




I'll contact them see if they have the seals .... Thnx

Cistern Siphon issue
 

On 06/10/2019 17:14, rick wrote:
I have a couple of concealed slimline cisterns.
They have started to leak water into WC, this is 100% not down the
overflow pipe, as water level is well below that.
Took it out cleaned all €¦ still the same (or worse if anything)Â* €¦. From
empty the infill €˜torbeck typeÂ* starts filling, all is fine until
around 50mm deep .. and the water starts to leak €¦. Assuming that the
bottom €˜main sealÂ* is OK, as nothing gets past that initially, only
leaks when it get in over the float, so my logic is that is must be
getting past the inner seal.

Are these spares items ?
The main seal aprox 66 OD and 48 ID has No.Â* 14.11.29Â* 1Â* DAL
The inner seal aprox 48 OD and 30 ID has No. 14.11.30Â* 8Â* DAL

Picture shows siphon, and the seals in the lower picture.
http://www.mediafire.com/file/p7yqjk...iphon.pdf/file

Had similar problem yesterday with a dual flush pushbutton. The tip in
this video about restricting the incoming flow worked:
https://www.youtube.com/watch?v=Y2f2Ao6SKgU
YMMV