Laminate flooring advice
 

On or about Fri, 25 Jul 2003 at 10:53 GMT,
Andy Jeffries illuminated us with:
On Fri, 25 Jul 2003 03:42:15 -0700, John Snow wrote:
We're moving into a new house next week and flooring has become quite
a priority. The current owners are taking the carpet from the lounge
and leaving a rather appealing bare concrete floor for us.

I take it you meant appalling rather than appealing ;-)

But now, after reading articles on this news group, I'm
beginning to wonder if I should have a go at the installation.

Go for it.

The general concepts I've seen so far are, you need to lay a
waterprrof membrane and fiber board padding.

You can get an underlay and AFAIK shouldn't need the board padding if you
have a level concrete floor.

And it will probably do a better job of sound deadening when you walk on it.

Being a DIY group I'm expecting you all to say I should do it myself,
but if I am a real novice is this wise on a 20' x 20' lounge ?

Yes, as an ex-novice I would definitely give it a go! We bought our first
house in March and have gone from "putting up a few shelves" before moving
in to laying laminate flooring in the smallest room, plastering, vinyl
flooring and all manor of minor enhancements. The Collins manual is the
best book I've found.

Take it slowly, read up about what you are doing and get the right tools.
It's not that hard once you get going. Two other snippets I've learnt the
hard way:

1)Practice before starting (hammering in the beading to cover the laminate
expansion gap upstairs without damaging the beading)

2)Pick somewhere less obvious to start with (rather than starting with
your bodged piece RIGHT by the door!)

Finally, if you do get the glue version, wipe the glue off straight away -
or plan on getting some decent glue remover from Screwfix - it doesn't
seem to come off with anything else!

Agree with all that. The difficulty of the job (in this case) is related to
the complexity of the "twiddly bits". If you've got 4 radiators in the room,
it's not very square and you've got alcoves all over the place in a small
room it will be more complicated and a lot slower than a large simple
rectangular room. Laying large numbers of uncut boards really is the easy
bit. Ditto the underlay.

--
Mark
Please remove nospam | For the rich, there's therapy.
to reply by email. | For the rest of us, there is fishing.
www.ayliffe.org |

Laminate flooring advice
 

It's not too dificult, I've done several and I would say that the trickiest
area is around a door ie. sawing into the architrave and sliding the board
under without gaps. Go for quality (I found Richard Burbridge to be easier to
fit than the cheaper brands) and do practise runs say with hardboard for
awkward bits.
Once you get going its easy but do use a mask cos that hdf is nasty stuff, good
luck
John

Laminate flooring advice
 

Thanks for all the advice...... a few more questions....

Is it better to use an all in one foam underlay (which seems quiet
thin) or to lay a membrane and fiber board ? Does the two layers offer
better heat insulation and reduce noise ?

If you do membrane and then fiber board - does the membrane go down
first ?

Apart from the tools that seem to be on offer at all laminate
retailers what special tools might I need ? I've heard people mention
good saws - do I need an electric one ?

Thanks again

J

Laminate flooring advice
 

John Snow wrote:

Is it better to use an all in one foam underlay (which seems quiet
thin) or to lay a membrane and fiber board ? Does the two layers offer
better heat insulation and reduce noise ?

I've tried both, and I definitely prefer the membrane + 1/4"
fiber board approach. Warmer and quieter.


If you do membrane and then fiber board - does the membrane go down
first ?

Yes.


Apart from the tools that seem to be on offer at all laminate
retailers what special tools might I need ? I've heard people mention
good saws - do I need an electric one ?

Depends how much you're doing. The first room I ever did I used
a hand saw. Not too much hard work. Last room I did I used my
trusty sliding chopsaw, which makes life much easier. I guess it
comes down to whether you want a new toy or not.

--
Grunff