Fuses made from copper strip
Looking through my bits box for a few fuses and holders for a 40 Kw alternator I use for 3 phase in my workshop, I was looking for some over 50 amps in case anything went wrong with any of my machines. I found 3 which look about right but they are just a strip of copper 2 and a quarter inches long and half an inch wide clamped into a suitable holder. As a guess I would say they would probably blow at a bit over 50 amps. The thickness is, as far as I can measure it on my caliper is 1/32nd of an inch
Does any clever chap know how I can calculate the current capacity from these measurements and so adjust it by cutting the strip in half, for example.
These 3 phases will be for fusing 3 separate 13 sockets but if I just put them in the lines they will also protect the outlet on 3 phase devices too.
I suppose I could just hook an ammeter in line and a heavy duty variac, which I have and just wind it up till it blows, but I do not have an unlimited supply of the copper strips and it is not very scientific, is it?
Anyone got a clue? Thanks George.
|