Bath Screen Hinge Leaking
 

Have just fitted a Bath Screen of the type with a fixed glass panel and
a hinged screen. The hinges are top and bottom with a seal running the
height of hinged section.

The hinges are essentiall cups fitted to the top and bottom of the fixed
section into witch a matching piece with a spigot on the hinged section
fits.

A PDF of the only instructions that came with it is he

http://dl.dropbox.com/u/23161586/BathPanel.pdf

The problem is that whilst everything else is sealed water from the
shower can get into the hinge around the cup and out the other side.
This is not just a dribble but a veritable spray if the shower is in the
right direction.

My gut feeling is that there should be some form of seal in the hinge,
perhaps an O ring of sorts although there is no evidence of a groove for
this.

Does anyone have any experience of this type of screen. Do they work and
if so what stop the water getting through?

Andrew

Bath Screen Hinge Leaking
 

On Oct 16, 11:27 am, Andrew May wrote:

My gut feeling is that there should be some form of seal in the hinge,
perhaps an O ring of sorts although there is no evidence of a groove for
this.

The hinge does have seal (item 10 in your fitting instructions)
however it may well be that water that hits this and runs is free to
run out of the bottom. To remedy, it might be worth considering
sealing the base on the outside as per step 8 of the instructions from
this similarly-designed screen from Coram:

http://www.coram.co.uk/pdfs/Frameles...nel%2006 .pdf

(I recently fitted one of these without the fixed panel portion, and
sealed it as advised without any problems)

Mathew

Bath Screen Hinge Leaking
 

On 16/10/2011 19:16, Mathew Newton wrote:
On Oct 16, 11:27 am, Andrew wrote:

My gut feeling is that there should be some form of seal in the hinge,
perhaps an O ring of sorts although there is no evidence of a groove for
this.

The hinge does have seal (item 10 in your fitting instructions)
however it may well be that water that hits this and runs is free to
run out of the bottom. To remedy, it might be worth considering
sealing the base on the outside as per step 8 of the instructions from
this similarly-designed screen from Coram:

http://www.coram.co.uk/pdfs/Frameles...nel%2006 .pdf

(I recently fitted one of these without the fixed panel portion, and
sealed it as advised without any problems)

Mathew

Useful instructions. Thanks. Much better than mine. The seal along the
spline (item 10 that you point out) is fine. The problem is the hinge at
the bottom (item 13). There is no seal between that and the turning
joint. Water from the shower can enter that and re-emerge on the wrong
side. That is where and O ring might be useful although there is no
croove to accommoadate one.

Andrew