Fridge freezer - how to remove top front panel (Bosch KGV3120GB/04 UK model)
 

Can anyone tell me how to remove the top front panel from this fridge
freezer.

I am referring to the panel which contains the temperature and on/off
switches. It is approximately 60cm wide by 5cm high by 4cm deep and
runs across the top of the fridge freezer above the fridge door.

I need to replace the switch which operates the interior light. This
is housed inside the top front panel - and is operated by the movement
of the door. The panel must pull out or hinge out or something - but
I cannot see how. There are two screws visible when I open the door -
these screws are underneath and rise vertically into the top front
panel. After I have removed the screws, the panel is slightly loose
but does not seem to "want" to come out willingly. Two years ago, an
engineer replaced this same switch. He did it in about two minutes,
so it must be really easy - but I do not want to force the panel and
cause damage.

Grateful for advice on what I have to do - rotate, pull, or what. I
have searched in vain for other screws.

There is a diagram provided by parts supplier BSH Appliance Care
https://quickfinder.consultens.com/qf32s/img/838229999$1_3508241.tif

I am trying to replace switch 067747 (shown near the top). The front
panel is part number 35 7112 1 etc on the diagram.

Fridge freezer - how to remove top front panel (Bosch KGV3120GB/04 UK model)
 

On 22 Sep 2003 09:50:47 -0700, (Joe) wrote:

Can anyone tell me how to remove the top front panel from this fridge
freezer.

On my freezer there are a couple of plastic blind rivits holding the panel. To
remove these you push in the centre pin, *only* part way in, otherwise the pin
goes right through and gets lost in the freezer inards.

--
Phil Addison
The uk.d-i-y FAQ is at http://www.diyfaq.org.uk/
Remove NOSPAM from address to reply

Fridge freezer - how to remove top front panel (Bosch KGV3120GB/04 UK model)
 

I have now replaced the switch, which was an easy task. This is what
I did:
Switch off power.
To remove the top front fascia panel.
1. Unscrew two vertical screws (white with cross heads).
2. Use finger nails to ease up the rear edge of the fascia panel along
its entire length - it "sits" across the top of the fridge.
3. Carefully rotate the fascia panel so that it can rest on top of the
fridge (it has cables leading to it).
To remove the switch.
1. Remove the clip-on mains cable connectors
2. Use a small screwdriver to press in the small plasic clip at rear
of the switch and apply downward pressure to push the rear of the
switch into the slot.
3. Do the same at the front of the switch.
4. Push the switch down and then rotate it sideways so that the
terminals clear the hole.
Reverse the process to install the new switch.

This Bosch fridge freezer was purchased in 2000; I have seen other
Bosch models which look as though they have the same type of fitting
arrangement.

I obtained the switch from Inter-Spares UK Ltd of
Unit 4, Lincoln Rd Ind Estate, Leadenham, Lincs, LN5 0PE
http://www.inter-spares.co.uk

Keywords to aid searching:
KGV3120GB KGV3120 KGV 3120
Bosch switch part number 067747