Universal / Commutator motor running slowly- puzzled!
I've got a 250W electric strimmer with a commutator type motor. It is
running much more slowly than it should (I would guess a few hundred instead of few thousand rpm). Both brushes spark as it runs. I have checked rotor windings with a multimeter across the brushes, rotating the rotor readings hover around 20-40 ohms. There are no obvious high or low points on the commutator, and I have polished the contacts and cleaned them and the gaps between with methylated spirits. The brushes are about 15mm long, and are held snug against the commutator by springs The field (stator) windings are also about 30 ohm each. The rotor spins fairly freely, there is one point where it rubs slightly, but only very slightly. Can anyone suggest what might be wrong? Regards, Nigel |
All times are GMT +1. The time now is 11:04 AM. |
Powered by vBulletin® Copyright ©2000 - 2024, Jelsoft Enterprises Ltd.
Copyright ©2004 - 2014 DIYbanter