Home |
Search |
Today's Posts |
|
UK diy (uk.d-i-y) For the discussion of all topics related to diy (do-it-yourself) in the UK. All levels of experience and proficency are welcome to join in to ask questions or offer solutions. |
Reply |
|
LinkBack | Thread Tools | Display Modes |
|
#1
Posted to uk.d-i-y
|
|||
|
|||
Why loft vents for boiler and immersion cylinders?
My heating system is a traditional boiler, loft tank, vented cylinder type
affair. The lower outlet to the coil inside the immersion cylinder tees off to a vent into the small tank in the loft which therefore vents the boiler side of things. The heated water in the cylinder fills from the bottom and the outlet at the top to the taps also tees off to a vent into the large loft tank. All fairly normal and so far so good. A few years ago I was up in the loft for the first time in ages and it was dripping wet in there. Everything stored had gone musty and water was running off the roof felt. Turned out the boiler vent was pumping over into the small tank which was consequently full of hot water and producing clouds of condensation. I tried the pump on its lowest setting and it still happened. I examined the pipe runs for the whole system and concluded that there was no point in a vent being there. The boiler fills up under gravity feed from the small tank and any excess pressure can just go straight back up there if it wants. The boiler certainly isn't going to explode and anyway there's a blow-off valve on the back of it. So I dug out an old radiator valve, slapped it on the end of the vent in the loft and turned it off. It's been that way for years and hasn't made a scrap of difference to anything other than the loft is now dry. So what purpose, if any, was the vent really serving? The vent to the main part of the cylinder doesn't overflow of course because it isn't pumped but again I see no point to it other than maybe to let any air in the cylinder get out. However wouldn't the air be immediately displaced out of a hot tap somewhere the first time the system was filled if there was no vent? -- Dave Baker www.pumaracing.co.uk *** Free account sponsored by SecureIX.com *** *** Encrypt your Internet usage with a free VPN account from http://www.SecureIX.com *** |
#2
Posted to uk.d-i-y
|
|||
|
|||
Why loft vents for boiler and immersion cylinders?
|
Reply |
Thread Tools | Search this Thread |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Forum | |||
immersion heating woes... | UK diy | |||
Leak in loft, came through ceiling - need to do anything? | UK diy | |||
Immersion Heater Timer wiring. | UK diy | |||
Indirect cylinders and immersion | UK diy | |||
Immersion heater question | UK diy |