DIY Dremel
 

dave wrote in message
...
I've rediscovered a small 24 VDC motor (dremel sized) that I'd fitted with
a
"pin chuck" (from 20 years ago!). I was just wondering if dremel
accessories
would fit? The chuck can take a max diam of 3mm shaft. Would that be too
small?
Thanks

3mm is the standard shank diameter for small burrs, mounted points, flap
wheels etc. 6mm is the shank size for bigger items. Dremel stuff will
therefore fit your chuck.
--
Dave Baker
www.pumaracing.co.uk


*** Free account sponsored by SecureIX.com ***
*** Encrypt your Internet usage with a free VPN account from http://www.SecureIX.com ***

DIY Dremel
 

Dave Baker wrote:
dave wrote in message
...
I've rediscovered a small 24 VDC motor (dremel sized) that I'd
fitted with a "pin chuck" (from 20 years ago!). I was just wondering
if dremel accessories would fit? The chuck can take a max diam of
3mm shaft. Would that be too small? Thanks

3mm is the standard shank diameter for small burrs, mounted points,
flap wheels etc. 6mm is the shank size for bigger items. Dremel stuff
will therefore fit your chuck.

Only a limited amount will fit, the predominent shank size IS 3.2
http://www.dremel-direct.com/acatalo...ol_Bits.html--

Sir Benjamin Midllethwaite