DIYbanter

DIYbanter (https://www.diybanter.com/)
-   UK diy (https://www.diybanter.com/uk-diy/)
-   -   Portland Cement - how to mix???? (https://www.diybanter.com/uk-diy/1166-portland-cement-how-mix.html)

Al August 15th 03 11:33 AM

Portland Cement - how to mix????
 
Hi.

I have half a bag of Portland cement that my builders left.

I need to put a swing in the garden and I'm supposed to bury part of
the legs legs in cement.

Do I just mix the cement with water or do I need to add some sand?
There are no instructions on the bag!

Thanks,

Al.

Toby August 15th 03 12:43 PM

Portland Cement - how to mix????
 
Al wrote:
Hi.

I have half a bag of Portland cement that my builders left.

I need to put a swing in the garden and I'm supposed to bury part of
the legs legs in cement.

Do I just mix the cement with water or do I need to add some sand?
There are no instructions on the bag!

Thanks,

Al.


The ratio is not too critical, but for this kind of application I'd go for
six parts ballast to one of cement. Mix it dry, then add small amounts of
water. Also as it is going straight into the ground aim for a damp mix
rather than sloppy. The curing is a chemical reaction not one of
evaporation.

Using this ratio conveniently uses three bags of ballast.

Ballast? It's sand, grit, small stone aggregate etc all mixed in one. To
make concrete you really need cement, sand and some aggregate.

Toby.



Rick Hughes August 15th 03 10:30 PM

Portland Cement - how to mix????
 

Do I just mix the cement with water or do I need to add some sand?
There are no instructions on the bag!




You want concrete not a mortar mix - use something like a 1:2:4 mix ....
i.e. 1 part cement, 2 parts sand, 4 parts chippings.

Mix dry first, then heap up and make a depression in middle, add some water,
and mix ... you should keep water low - just enough to make all parts of
the mix join together, the test is if you can squeeze it in your hand and it
will form a ball without falling apart, then it's about right - if water
squeezes out - it's too wet (add a bit of cement & sand to dry out)

(Or if you chop up and down with a shovel it will keep the shapes made
without slumping back.)

Pack into the hole - ram down with an offcut of wood and then later in the
day water in with a watering can. - job done.

If you use a wet mix it will be difficult to keep post upright, and there is
no need for loads of water.

But for a swing none of the above is critical.

Rick




All times are GMT +1. The time now is 08:35 PM.

Powered by vBulletin® Copyright ©2000 - 2024, Jelsoft Enterprises Ltd.
Copyright ©2004 - 2014 DIYbanter