Does anyone know if a list of various shank dimensions on the internet?

I'm attmpting to determine the exact measurements of each Morse
Taper(so I can determine which if any can be bored or ground to make
another).

There is some info on measuring shanks in my Machinery's Handbook(page
713), but I can't seem to find a list designating the common shanks.

Then again, it is a big book, a perhaps I am not searching with the
correct terms.

Any help would be appreciated.

Thanks a lot.

Darren Harris
Staten Island, New York.

wrote:
Does anyone know if a list of various shank dimensions on the internet?

I'm attmpting to determine the exact measurements of each Morse
Taper(so I can determine which if any can be bored or ground to make
another).

There is some info on measuring shanks in my Machinery's Handbook(page
713), but I can't seem to find a list designating the common shanks.

Then again, it is a big book, a perhaps I am not searching with the
correct terms.

Any help would be appreciated.

Thanks a lot.

Darren Harris
Staten Island, New York.


Look in the Machinery's Handbook index for: Morse, Tapers.

Or you can go to the thumb tab for Tooling, and look for the chapter on
Standard Tapers.


Westopher

wrote in message Does anyone know if a list of
various shank dimensions on the internet?

I'm attmpting to determine the exact measurements of each Morse
Taper(so I can determine which if any can be bored or ground to make
another).

http://www.littlemachineshop.com/Reference/Tapers.php

Or:

http://www.woodturners.org/tech_tips...aper_sizes.htm

Or:

http://www.morsecuttingtools.com/reference/taper.html

http://www.morsecuttingtools.com/ref...aperchart.html

Best Regards,
Keith Marshall


"I'm not grown up enough to be so old!"