southbend heavy 10
 

the place I work for is pasturing a south bend lathe , 10x30 approximately,
it ha spent the last 20 years since new as a
collet lathe to make small bushing rods and what not

it is completely tooled, quick change aloris , steady , follow rests ,
chucks , 5c collet set up, really nice little machine , could use some work
to tighten up the spindle bearings , if any one is interested I will post
some pictures , otherwise I will probably clean it up and put it on ebay

In article , williamhenry says...

the place I work for is pasturing a south bend lathe , 10x30 approximately,
it ha spent the last 20 years since new as a
collet lathe to make small bushing rods and what not

it is completely tooled, quick change aloris , steady , follow rests ,
chucks , 5c collet set up, really nice little machine , could use some work
to tighten up the spindle bearings , if any one is interested I will post
some pictures , otherwise I will probably clean it up and put it on ebay

It would be a great help if you could indicate where this machine
is located, and an approximate asking price. If you did that, I
doubt it would ever make it to ebay. Photos would be nice,
as you suspected.

Jim


--
==================================================
please reply to:
JRR(zero) at pkmfgvm4 (dot) vnet (dot) ibm (dot) com
==================================================

it is in Nashville , not really sure on price as I have not given the
machine a good cleaning and inspection yet, want to make sure
any buyer is fully informed

interested parties can email me personally and i will send pictures out over
the weekend