FS Mill
 

I listed this mill for sale here a while back and had a couple of requests
for pictures that I didn't have at the time.

The mill is a KempSmith horizontal mill with a Bridgeport head on the
overarm. I replaced the spindle bearings in the Bridgeport head when I
first bought the mill and I probably have put less than 40 hours on it since
then. The table is ~12" X 50" and in pretty good condition as the picture
shows. The motor on the horizontal part is 7-1/2 HP, you could use that
motor for a phase converter to run the Bridgeport head if you wanted... or
use 7-1/2 HP for power feed for the 1HP spindle motor :-) I have used the
horizontal spindle for end milling before, eliminating the need for a large
angle plate. The location is in DuQuoin, IL, about 90 miles SE of StLouis
MO. Asking $1000. Estimated weight is 4500lbs, have fork lift and can load
it.

Pictures of mill (with junk around it):
http://home.midwest.net/~regor/bin41/mill1.jpg
http://home.midwest.net/~regor/bin41/mill2.jpg

I digitally enhanced the photos and stuck them in the dropbox (hope that's
okay). Filenames are as follows:

mill1a.jpg
mill2a.jpg
mill1a2a.txt

Jon

"Ignoramus6609" wrote:
These pictures are not exactly very telling. I see a dark object and
light from behind it. Can you try using a flash on your camera.

i

RogerN wrote:
I listed this mill for sale here a while back and had a couple of
requests
for pictures that I didn't have at the time.

The mill is a KempSmith horizontal mill with a Bridgeport head on the
overarm. I replaced the spindle bearings in the Bridgeport head when I
first bought the mill and I probably have put less than 40 hours on it
since
then. The table is ~12" X 50" and in pretty good condition as the
picture
shows. The motor on the horizontal part is 7-1/2 HP, you could use that
motor for a phase converter to run the Bridgeport head if you wanted...
or
use 7-1/2 HP for power feed for the 1HP spindle motor :-) I have used
the
horizontal spindle for end milling before, eliminating the need for a
large
angle plate. The location is in DuQuoin, IL, about 90 miles SE of
StLouis
MO. Asking $1000. Estimated weight is 4500lbs, have fork lift and can
load
it.

Pictures of mill (with junk around it):
http://home.midwest.net/~regor/bin41/mill1.jpg
http://home.midwest.net/~regor/bin41/mill2.jpg





--