Metalworking (rec.crafts.metalworking) Discuss various aspects of working with metal, such as machining, welding, metal joining, screwing, casting, hardening/tempering, blacksmithing/forging, spinning and hammer work, sheet metal work.

 
 
LinkBack Thread Tools Search this Thread Display Modes
Prev Previous Post   Next Post Next
  #1   Report Post  
Richard Ferguson
 
Posts: n/a
Default Drilling Speed and pilot drill questions

I was going through my Machinery Handbook, and trying to figure out the
optimum drilling RPM. I ended up having to look at one table to get
recommended FPM for the material, and then another table to convert FPM
to RPM. The RPMs seem high to me, so I wanted to run them by you guys
as a sanity check.

For HSS drills in low carbon steel, I read 100 FPM, and maybe half that
for harder steel.

Converting that to RPM, I will list a range of RPMs for a given drill
diameter.

1/4 inch - 1500 to 750 RPM
1/2 inch - 750 to 400 RPM
1 inch - 400 to 200 RPM

Is this anywhere near right? If so, I need to change the pulleys on my
drill press, as I drill a lot of holes in the range of 1/4 inch to 1/2
inch, maybe set it to 750 RPM or so. It is a pain to change, so I want
to pick a compromise value.

The other question relates to pilot drills. I did not find anything in
my Machinery handbook on pilot drills. Does it make any sense to use a
pilot drill for finished hole sizes of 1/4 inch or less? If so, what is
the rule of thumb for pilot drill sizes? Do I need to change RPM
between the pilot hole and the final drill size?

Assume that most of my drilling is in low carbon steel of 1/4 inch to
5/8 inch thickness.

Thanks in advance.

Richard

 
Thread Tools Search this Thread
Search this Thread:

Advanced Search
Display Modes

Posting Rules

Smilies are On
[IMG] code is On
HTML code is Off
Trackbacks are On
Pingbacks are On
Refbacks are On


Similar Threads
Thread Thread Starter Forum Replies Last Post
Drill help barry martin Home Repair 0 November 2nd 04 11:27 PM
Bench-top drill press recommendation? and what I found so far. [email protected] Metalworking 9 May 20th 04 03:38 AM
Advice on a drill press, & misc questions Ryan Wright Metalworking 17 January 16th 04 04:22 PM
drilling steel? Dave UK diy 26 October 29th 03 03:03 PM
drilling steel? Dave Metalworking 29 October 29th 03 03:03 PM


All times are GMT +1. The time now is 01:10 PM.

Powered by vBulletin® Copyright ©2000 - 2024, Jelsoft Enterprises Ltd.
Copyright ©2004-2024 DIYbanter.
The comments are property of their posters.
 

About Us

"It's about DIY & home improvement"