Schrader valves
 

I need to find schrader valves for a project. Straight, nickel plated.

Are these valves normally brass? Would silver solder be appropriate for handling 175-200 psi air?

thanks

gary

Schrader valves
 

wrote in message
...
I need to find schrader valves for a project. Straight, nickel
plated.

Are these valves normally brass? Would silver solder be appropriate
for handling 175-200 psi air?

thanks

gary

Try the air compressor section of a hardware store.

https://www.amazon.com/Control-Devic...66446079&psc=1

Schrader valves
 

On Sat, 17 Aug 2019 06:47:22 -0700 (PDT)
wrote:

I need to find schrader valves for a project. Straight, nickel plated.

Are these valves normally brass? Would silver solder be appropriate for handling 175-200 psi air?

Looks like McMaster may have some too:

https://www.mcmaster.com/schrader-valves

--
Leon Fisk
Grand Rapids MI

Schrader valves
 

On 8/17/2019 6:47 AM, wrote:
I need to find schrader valves for a project. Straight, nickel plated.

Are these valves normally brass? Would silver solder be appropriate
for handling 175-200 psi air?

thanks

gary



Depends on the application. You can get them in all kinds of
configurations. Most use a rubber seal of some kind. I think I have a
bag on my parts board with some that that have an NPTF thread instead of
a rubber seal.

McMaster is a good source, but if its a test or throw away application
look on places like Ebay too.

Schrader valves
 

On Sat, 17 Aug 2019 07:31:33 -0700, Bob La Londe
wrote:


On 8/17/2019 6:47 AM, wrote:
I need to find schrader valves for a project. Straight, nickel plated.

Are these valves normally brass? Would silver solder be appropriate
for handling 175-200 psi air?

thanks

gary



Depends on the application. You can get them in all kinds of
configurations. Most use a rubber seal of some kind. I think I have a
bag on my parts board with some that that have an NPTF thread instead of
a rubber seal.

McMaster is a good source, but if its a test or throw away application
look on places like Ebay too.
With brute force and ignorance, I strip the rubber off used tire valve
stems (from the waste bucket at the tire shop), wire wheel them clean
and silver solder them into a drilled out (1/4") quick-connect plug.
Of course I don't use higher than 100 PSI, but I can't envision a
problem at reasonable pressures up to the limit of the valve itself.

Schrader valves
 

On Saturday, August 17, 2019 at 8:47:25 AM UTC-5, wrote:
I need to find schrader valves for a project. Straight, nickel plated.

Are these valves normally brass? Would silver solder be appropriate for handling 175-200 psi air?

thanks

gary

https://www.napaonline.com/en/p/NTH90416