Metalworking (rec.crafts.metalworking) Discuss various aspects of working with metal, such as machining, welding, metal joining, screwing, casting, hardening/tempering, blacksmithing/forging, spinning and hammer work, sheet metal work.

Reply
 
LinkBack Thread Tools Search this Thread Display Modes
  #1   Report Post  
Old December 18th 18, 01:35 AM posted to rec.crafts.metalworking
external usenet poster
 
First recorded activity by DIYBanter: Aug 2006
Posts: 3,067
Default 18 pin Music Box mechanisms


the wife bought a music box some time back and I foolishly said
"oh, of course I can fix it." Found it today.

Got the mechanism out, and ... it needs disassembly. Or
lubrication, or something. But, it is pot metal, so "I will be very
careful."
Which I had a Real Drill Press, but will make do with the dremel
accessory. Ufda.
--
pyotr filipivich.
Discussing the decline in the US's tech edge, James Niccol once wrote
"It used to be that the USA was pretty good at producing stuff teenaged
boys could lose a finger or two playing with."

Reply
Thread Tools Search this Thread
Search this Thread:

Advanced Search
Display Modes

Posting Rules

Smilies are On
[IMG] code is On
HTML code is Off
Trackbacks are On
Pingbacks are On
Refbacks are On


Similar Threads
Thread Thread Starter Forum Replies Last Post
Taper pin vs split pin Bob Engelhardt Metalworking 21 January 26th 10 01:55 PM
switching out 2 pin for 3 pin sockets in my victorian home Si[_3_] Home Repair 45 May 30th 09 07:07 PM
Replace 3-pin with 2-pin shaver plug AnthonyL UK diy 11 March 4th 07 11:28 AM
4 pin vs. 2 pin crystal (3.57MHz) Farce Milverk Electronics 6 November 27th 06 11:06 PM
FS: New: 24 Pin Sockets and 40 Pin Sockets Jerry Rakar Electronics 1 February 4th 04 09:38 AM


All times are GMT +1. The time now is 02:02 PM.

Powered by vBulletin® Copyright ©2000 - 2019, Jelsoft Enterprises Ltd.
Copyright 2004-2019 DIYbanter.
The comments are property of their posters.
 

About Us

"It's about DIY & home improvement"

 

Copyright © 2017