About Us

Gunner Asch[_6_]

On Thu, 8 Mar 2018 20:56:53 -0800 (PST), wrote:

On Saturday, February 17, 2018 at 5:06:29 PM UTC-5, Ralph Mowery wrote in sci.electronics.repair:
In article ,
says...

On Friday, January 26, 2018 at 2:45:57 PM UTC-5, BenAnd wrote:
Repairing metal housing.

7/8" steel tube with ends slightly rounded inwards.
I need to remove all and a little more of the rounding inwards.

What material bit for either 1/4" OR 1/8" shank hand drill motor or
Dremel is best to use ?

I have many of these to do.

Can you just re-cut the end?
Maybe a step drill bit, or a conical bit.
(A dremel sounds a bit wimpy for the job, unless it's thin walled
SS.)

George H.

Did anyone mention a tapered reamer ? The pipe threading machines
usually
have them built in.

Do they work on rigid? pipe, too?

Yep.

---
This email has been checked for viruses by Avast antivirus software.
https://www.avast.com/antivirus

Thread Tools	Search this Thread
Show Printable Version	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Steel Grind	BenAnd	Electronics Repair	7	March 9th 18 04:57 AM
Grind-It-Yourself Drill bits	N. Thornton	UK diy	16	March 29th 04 12:42 AM
How to grind shsrp edges of glass?	[email protected]	UK diy	7	September 2nd 03 01:34 AM
Spindle rebore/grind for a Denbigh horizontal	Kathy	Metalworking	3	August 31st 03 12:04 AM
How to grind lathe bits on HF carbide tool grinder?	Wally Blackburn	Metalworking	3	August 30th 03 08:41 PM

Menu

About Us