Jarvis 303 Tapping head collet sizing
 

I recently bought a Jarvis 303 tapping head with a Jacobs chuck no. 440-J5.
After looking in the current Enco catalog (page 310) at the collets in an
effort to find the one that fits this chuck I am still in the dark. Can one
of you wise men or ladies steer me in the right direction? They list a
Jacobs tap chuck but do not reference a number.
Steve

Jarvis 303 Tapping head collet sizing
 

Steve Peterson wrote:
I recently bought a Jarvis 303 tapping head with a Jacobs chuck no. 440-J5.
After looking in the current Enco catalog (page 310) at the collets in an
effort to find the one that fits this chuck I am still in the dark. Can one
of you wise men or ladies steer me in the right direction? They list a
Jacobs tap chuck but do not reference a number.
Steve



I have a Jacobs 440-J10 with two Rubberflex collets, I wonder if they're
the same as for the J5. Not for sale, except with the chuck, and you
already have one of those.
Anyway if it helps, here are the specs on the two collets I have:
No. J441--capacity, #10 to 1/2"
No. J440--capacity, 5/16"-5/8"
Each collet has six jaws, about 1/8" thick, set in rubber--5/8" long,
and a 20 degree cone angle. Largest diameter across the points is 1 3/16".

Ken Grunke
SW Wisconsin
http://www.token.crwoodturner.com/
Member, Coulee Region Woodturners AAW chapter
http://www.crwoodturner.com/



-----= Posted via Newsfeeds.Com, Uncensored Usenet News =-----
http://www.newsfeeds.com - The #1 Newsgroup Service in the World!
-----== Over 100,000 Newsgroups - 19 Different Servers! =-----

Jarvis 303 Tapping head collet sizing
 

"Ken Grunke" wrote in message
...
Steve Peterson wrote:
I recently bought a Jarvis 303 tapping head with a Jacobs chuck no.
440-J5.
After looking in the current Enco catalog (page 310) at the collets in
an
effort to find the one that fits this chuck I am still in the dark. Can
one
of you wise men or ladies steer me in the right direction? They list a
Jacobs tap chuck but do not reference a number.
Steve



I have a Jacobs 440-J10 with two Rubberflex collets, I wonder if they're
the same as for the J5. Not for sale, except with the chuck, and you
already have one of those.
Anyway if it helps, here are the specs on the two collets I have:
No. J441--capacity, #10 to 1/2"
No. J440--capacity, 5/16"-5/8"
Each collet has six jaws, about 1/8" thick, set in rubber--5/8" long,
and a 20 degree cone angle. Largest diameter across the points is 1 3/16".

Ken Grunke
SW Wisconsin
http://www.token.crwoodturner.com/
Member, Coulee Region Woodturners AAW chapter
http://www.crwoodturner.com/

Thanks for the reply. From your description they seem like the right size.
How does your chuck attach? This one is retained by a pin the way it appears
although I have not taken it off the tapping head. How dear is the chuck and
collets to you? Maybe we could work out a trade or cash if need be. Contact
me off list at
speterooooooooatoooooooowctaooooooodotooooooooonet take out the "o"s