On Sat, 2 May 2015 07:35:42 +0000 (UTC), John Doe
wrote:

Are there any common drill attachments that go in place of the chuck?

So that when the chuck is removed, the attachment can be screwed on in
place of the chuck.

I just need a keyword to search for. Assuming it exists. Of course it
would be drill chuck thread specific.

Thanks.

I assume that your chick is too small for the drill you want to use. If
that is so use a pin vise in the chuck.



Regards,

Boris Mohar

Got Knock? - see:
Viatrack Printed Circuit Designs (among other things) http://www.viatrack.ca

void _-void-_ in the obvious place



---
This email has been checked for viruses by Avast antivirus software.
http://www.avast.com

Boris Mohar fired this volley in
news
I assume that your chick is too small for the drill you want to use. If
that is so use a pin vise in the chuck.

Let's see if I understand...

If the chuck is too SMALL for the drill bit, use a reducing device known as
a pin vise, in order to make it smaller, yet.

Yep... that seems to be an 'interesting' strategy.

Lloyd