DIYbanter

DIYbanter (https://www.diybanter.com/)
-   Metalworking (https://www.diybanter.com/metalworking/)
-   -   Splined shaft questions.... (https://www.diybanter.com/metalworking/329179-re-splined-shaft-questions.html)

David Lesher September 29th 11 04:38 PM

Splined shaft questions....
 
Gunner Asch writes:


There is some wear on the splined shaft from the transmission and the
clutch basket is wobbling on it with that loose nut.

....
Whats the fix for this? New guts for both? Steel epoxy with release
agent on one half? I dont think there is more than .010 wear..but there
is wear and the basket rocks significantly.


Vague half-memory:

Some BMW 2002 sedans had an issue with the output splines
fretting. Then at some point, usually startup from a stoplight,
they'd fail...and the unloaded engine would blow.

There was a extra-special epoxy BMW used to stop the fretting.
--
A host is a host from coast to
& no one will talk to a host that's close........[v].(301) 56-LINUX
Unless the host (that isn't close).........................pob 1433
is busy, hung or dead....................................20915-1433


All times are GMT +1. The time now is 10:54 PM.

Powered by vBulletin® Copyright ©2000 - 2024, Jelsoft Enterprises Ltd.
Copyright ©2004 - 2014 DIYbanter