Home |
Search |
Today's Posts |
|
Metalworking (rec.crafts.metalworking) Discuss various aspects of working with metal, such as machining, welding, metal joining, screwing, casting, hardening/tempering, blacksmithing/forging, spinning and hammer work, sheet metal work. |
Reply |
|
LinkBack | Thread Tools | Display Modes |
|
#1
Posted to rec.crafts.metalworking
|
|||
|
|||
How to set up for cutting extractor relief cuts on barrel breech?
I have a Rockwell 21-100 mill with a head that rotates side to side.
The head on it's side will run into the table before I get the barrel in the vise on the table high enough to get the spindle parallel with the barrel. I could cut perpendicular to the barrel, and then file out the uncut corners by hand. I am looking at a Ruger #1 re barrel right now. TIA |
#2
Posted to rec.crafts.metalworking
|
|||
|
|||
How to set up for cutting extractor relief cuts on barrel breech?
wrote in message ... I have a Rockwell 21-100 mill with a head that rotates side to side. The head on it's side will run into the table before I get the barrel in the vise on the table high enough to get the spindle parallel with the barrel. I could cut perpendicular to the barrel, and then file out the uncut corners by hand. I am looking at a Ruger #1 re barrel right now. Put the vise on a riser. Sheesh... |
#3
Posted to rec.crafts.metalworking
|
|||
|
|||
How to set up for cutting extractor relief cuts on barrel breech?
On Sep 8, 4:56*pm, "PrecisionmachinisT"
wrote: wrote in message ... I have a Rockwell 21-100 mill with a head that rotates side to side. The head on it's side will run into the table before I get the barrel in the vise on the table high enough to get the spindle parallel with the barrel. I could cut perpendicular to the barrel, and then file out the uncut corners by hand. I am looking at a Ruger #1 re barrel right now. Put the vise on a riser. Sheesh... Or mark it out with machinist's blue and file it out by hand. Sometimes hand work is faster. Could probably have gotten it done by the time you get a reply. Stan |
#4
Posted to rec.crafts.metalworking
|
|||
|
|||
How to set up for cutting extractor relief cuts on barrel breech?
If I understand, you're asking how to machine on the end of a long cylinder. put vice in angle block so its on its side. camp part so it goes below table in front on one side of knee adjust spindle ram over part machine Karl |
#5
Posted to rec.crafts.metalworking
|
|||
|
|||
How to set up for cutting extractor relief cuts on barrel breech?
"Karl Townsend" wrote in message ... If I understand, you're asking how to machine on the end of a long cylinder. put vice in angle block so its on its side. camp part so it goes below table in front on one side of knee adjust spindle ram over part machine It's not a Bridgeport. http://www.practicalmachinist.com/vb...l-img_7094.jpg |
Reply |
Thread Tools | Search this Thread |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Forum | |||
Connect 5/16" OD 22LR steel barrel liner to larger OD barrel? | Metalworking | |||
Cutting / measuring odd angles for miter cuts | Home Repair | |||
fa: Stihl Concrete cutting saw (also cuts metal, of course) | Metalworking | |||
Relief | Home Repair | |||
Oak barrel tap | UK diy |