Home |
Search |
Today's Posts |
|
Metalworking (rec.crafts.metalworking) Discuss various aspects of working with metal, such as machining, welding, metal joining, screwing, casting, hardening/tempering, blacksmithing/forging, spinning and hammer work, sheet metal work. |
Reply |
|
LinkBack | Thread Tools | Display Modes |
#1
Posted to rec.crafts.metalworking
|
|||
|
|||
Homemade Draw Bar
Sounds just like my Emco lathe/mill. The mill uses a MT2 collet with an adapter to mate with a metric drawbar. look at the Yahoo EMCO lathe news group. Lost of posts about the adapter there.
I can send you the specs of the adapter if you wish. Paul |
#2
Posted to rec.crafts.metalworking
|
|||
|
|||
Homemade Draw Bar
"KD7HB" wrote in message
... Sounds just like my Emco lathe/mill. The mill uses a MT2 collet with an adapter to mate with a metric drawbar. look at the Yahoo EMCO lathe news group. Lost of posts about the adapter there. I can send you the specs of the adapter if you wish. Paul Thanks Paul, but I can measure it up and make it this afternoon with no problems. I was mostly curious if there were any snafus to watch out for. I'm already half done. Was just taking a soda break. |
Reply |
Thread Tools | Search this Thread |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Forum | |||
Homemade Draw Bar | Metalworking | |||
DIY stands for Draw It Yourself, right? | UK diy | |||
Draw down boiler? ? ? | Home Repair | |||
Car current draw | Home Repair | |||
what amp draw will I likely see? | Home Repair |