Metalworking (rec.crafts.metalworking) Discuss various aspects of working with metal, such as machining, welding, metal joining, screwing, casting, hardening/tempering, blacksmithing/forging, spinning and hammer work, sheet metal work.

 
 
LinkBack Thread Tools Search this Thread Display Modes
Prev Previous Post   Next Post Next
  #1   Report Post  
Posted to rec.crafts.metalworking
external usenet poster
 
Posts: 3,286
Default 3 phase service

"The Kid" is putting in underground wiring to his outbuildings. For
now, power will come from the house to the shop.

The shop sits twenty feet from a three phase line. future plans is to
install a three phase service to the shop, cut the ordinal transformer
out, and then feed one phase back to the house from the wiring being
installed now.

OK, a one phase house service has two 110 legs on the same phase
opposite polarity to get 220 across the two hot wires, neutral is the
center tap. As I understand it you in effect get three 110 hot wires
120 degrees apart in the phasing for three phase with the center tap
for neutral.

So, can you run single phase 220 off this? Need any special provisions
installed now? He's putting in conduit - four wires - two hot, neutral
and ground.

Karl
 
Thread Tools Search this Thread
Search this Thread:

Advanced Search
Display Modes

Posting Rules

Smilies are On
[IMG] code is On
HTML code is Off
Trackbacks are On
Pingbacks are On
Refbacks are On


Similar Threads
Thread Thread Starter Forum Replies Last Post
Single Phase Backup Generator to Three Phase Mains Supply? [email protected] Home Repair 3 January 24th 08 02:30 AM
profit-motive question: single phase adapter for 3-phase motor drives gwes Metalworking 8 October 5th 07 08:33 PM
3-phase used for 1-phase (split-phase) power SRK Home Repair 9 July 22nd 06 11:01 AM
230 3 phase or 120/208 3 Phase service? gtslabs Metalworking 10 July 24th 05 10:38 PM
WANTED: 50hp Phase Converters - - - Tax Deductible - - EAGLE SCOUT Gov't Service Project [email protected] Metalworking 23 January 3rd 05 07:57 AM


All times are GMT +1. The time now is 10:44 AM.

Powered by vBulletin® Copyright ©2000 - 2024, Jelsoft Enterprises Ltd.
Copyright ©2004-2024 DIYbanter.
The comments are property of their posters.
 

About Us

"It's about DIY & home improvement"