Home |
Search |
Today's Posts |
|
Metalworking (rec.crafts.metalworking) Discuss various aspects of working with metal, such as machining, welding, metal joining, screwing, casting, hardening/tempering, blacksmithing/forging, spinning and hammer work, sheet metal work. |
Reply |
|
LinkBack | Thread Tools | Display Modes |
#1
Posted to rec.crafts.metalworking
|
|||
|
|||
RFQ
Sure,
http://www.emachineshop.com/ DJ On Feb 14, 10:52 am, kthr33 wrote: I need a part quoted. It's mabe from 5/16" square 316 Stainless steel bar stock. Overall finished part length is 9/16". Of that length, 7/16" is turned down to 0.230", the other 1/8" is left 5/16" sq. A blind hole is drilled from one end to allow tapping to a full thread depth of 0.410"-0.390". Thread is #10-24. Tolerances, fraction +/- 0.010", decimal +/- .005. Machine finish is 125. The only critical issue is that the drill point does not breach the end. This is a thread insert for a molded plastic part. May be a one time requirement of 1000 pcs. Any suggestions of where this may be quoted would be greatly appreciated. Thanks, K. |
Reply |
Thread Tools | Search this Thread |
Display Modes | |
|
|