 |
|
| Metalworking (rec.crafts.metalworking) Discuss various aspects of working with metal, such as machining, welding, metal joining, screwing, casting, hardening/tempering, blacksmithing/forging, spinning and hammer work, sheet metal work. |
| Reply |
|
|
LinkBack | Thread Tools | Display Modes |
|
#1
Posted to rec.crafts.metalworking
|
|||
|
|||
Worm Gear Size?
I need help in find a brass worm gear for an upright bass fiddle. The
gear is brass and 1 3/8 inch diam. by little under 1/4 thick 24 teeth. How do I measure this to look for replacement? |
|
#2
Posted to rec.crafts.metalworking
|
|||
|
|||
|
Worm Gear Size?
In article ,
dale randall wrote: I need help in find a brass worm gear for an upright bass fiddle. The gear is brass and 1 3/8 inch diam. by little under 1/4 thick 24 teeth. How do I measure this to look for replacement? Go to Boston Gear (http://www.bostongear.com/) and ask them to help. Joe Gwinn |
|
#3
Posted to rec.crafts.metalworking
|
|||
|
|||
|
Worm Gear Size?
I would just look for an instrument repair shop.
They prolly have what you want off the shelf. Just a bit more expensive. DOC Have robots. Will travel. http://www.robot-one.ca On Sep 21, 12:49 pm, Joseph Gwinn wrote: In article , dale randall wrote: I need help in find a brass worm gear for an upright bass fiddle. The gear is brass and 1 3/8 inch diam. by little under 1/4 thick 24 teeth. How do I measure this to look for replacement? Go to Boston Gear (http://www.bostongear.com/) and ask them to help. Joe Gwinn |
| Reply |
| Thread Tools | Search this Thread |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Forum | |||
| DRIVE GEAR & WORM question | Metalworking | |||
| rating of old cast iron S&S manual worm gear winch? | Metalworking | |||
| Ridgid R3210 Worm-Gear Circular Saw Review | Metalworking | |||
| Gear hobber gear train set-up | Metalworking | |||
| What might this worm gear fit? | Metalworking | |||
Linear Mode
