MY servo powerfeed is not working.
 

I have a servo type power feed on my bridgeport. and it has an electrical
problem. it has good brushes. and the micro switch seem to go on an off. I do
not see the rehostas working but i do not now what it should raise and lower
the voltage to. does anybody have a schematic for these units.

MY servo powerfeed is not working.
 

http://servoproductsco.com/index.html

This should get you started.

Gary R.

MY servo powerfeed is not working.
 

--I've got a Servo system I'll sell you; never use it anymore...
Make offer?

--
"Steamboat Ed" Haas : Somewhere in Texas a
Hacking the Trailing Edge! : village has lost an idiot...
http://www.nmpproducts.com/intro.htm
---Decks a-wash in a sea of words---

MY servo powerfeed is not working.
 

Check your limit switch for the ends of the travel located on the table
(not in the box itself). If you run it hard against the switch it will
act as a hard stop and jam the internal microswitch. Just disassemble
and free it up.

I have some hand drawn prints I got from Lewis Harwick that I planned to
scan and put in the dropbox, never got done. Suppose I could get
somewhat motivated. But a sunny Sunday afternoon might get in the way of
that!

Asp3211968 wrote:

I have a servo type power feed on my bridgeport. and it has an electrical
problem. it has good brushes. and the micro switch seem to go on an off. I do
not see the rehostas working but i do not now what it should raise and lower
the voltage to. does anybody have a schematic for these units.

MY servo powerfeed is not working.
 

On Sun, 11 Jul 2004 15:12:52 GMT, steamer wrote:

--I've got a Servo system I'll sell you; never use it anymore...
Make offer?

Hummm I wonder if it would fit on a Gorton 1-22?

Gunner

That rifle hanging on the wall of the working-class flat or labourer's
cottage is the symbol of democracy. It is our job to see that it stays
there.
- George Orwell

MY servo powerfeed is not working.
 

i would like the hand drawn schematic. if you scan it i will post it if you
want. as for making an offer what size is the servo and what would be a
realistic figure.

MY servo powerfeed is not working.
 

If you still haven't gotten it fixed, check with these guys. The guy who
answers the phone knows his stuff. (His web site is a bit marginal but
I don't care about THAT!)
http://www.cal-metrics.com/

Asp3211968 wrote:

i would like the hand drawn schematic. if you scan it i will post it if you
want. as for making an offer what size is the servo and what would be a
realistic figure.