3 Clausing 4902 lathes for sale
 

Another machining program « bites [bytes?] the dust »

Because of a lack of enrollment, apparently due to a lack of local
area jobs, [We have been unable to locate any of the companies who
continue to claim they are short of machinists, mechanics and
technicians] our college has reluctantly decided to suspend our
machining classes and «mothball» the equipment.

Rather than put the equipment is storage in an unheated building,
allow it to rust, and then sell it for scrap after a suitable period
of aging, We would rather sell these at scrap prices now to someone
who will use them.

We have three 4902 Clausing lathes [9 inch swing 24 inches between
centers] immediately available. These machines are wired for 60 cycle
3 phase 220 volts.

(2) lathes are in reasonable shape, and (1) is a «hangar queen» with
the QC gearbox and compound [top] slide missing.

All three lathes have been recently repainted. The drive belts on the
two operational lathes have been replaced as was one set of variable
speed jackshaft bearings. A key is [apparently] sheared in the
gearbox on one lathe so that the B thread range is not operational.
Gears appears to be fine with careful «flash-light» check. Both
lathes come complete with a universal 3-jaw chuck in good operating
condition, lantern tool holders and miscellaneous bits and pieces. A
photocopied factory manual comes with the lathes. Lathes are well
used but not abused. Gibbs and feed-screws [cross-slide and compound]
need adjusting but are fully functional. Spindle bearings and
lead-screw seem to be fine. Good close tolerance work has recently
been done on both operational lathes this semester.

Lathes are located in the Panhandle of Texas

On 2 days notice we can have a fork truck available to load into your
vehicle. [Be sure to bring plenty of tie-downs/rope to keep the lathe
from shifting!]

If you are interested, contact me by email at